Throttle Pedal Sensor Calibration{1269, 1913, 5736, 5737, 7610, 7620}
- Compact Wheel Loader:
- 906H2 (S/N: JRF1-UP)
- 907H2 (S/N: JRS1-UP)
- 908H2 (S/N: JRD1-UP)
- 907H2 (S/N: JRS1-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the information that is identified below.
Problem
The accelerator pedal position sensor on the above listed machines becomes out of calibration. Becoming out of calibration results in low travel speed, followed by not shifting into high gear. Software goes back to default at Key Off and does not remember new settings.
Solution
Until new software is released, do the following within a one second cycle time:
Turn the key to the On position (Do not need to run the engine), and press the accelerator pedal to the floor and release.
Note: You do not have to start and rev the engine to maximum RPM.
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Cooling Fan Reversing - Test
D6R2 Track-Type Tractor Engine Supplement Air Cleaner - Remove and Install
926M, 930M and 938M Wheel Loaders Power Train Manifold - Remove and Install - Hydrostatic
926M, 930M and 938M Wheel Loaders Power Train Accumulator - Remove and Install - Hydrostatic
D6R2 Track-Type Tractor Engine Supplement Electric Starting Motor - Remove and Install
926M, 930M and 938M Wheel Loaders Power Train Gear Pump (Hydrostatic, Charge) - Assemble
926M, 930M and 938M Wheel Loaders Power Train Gear Pump (Hydrostatic, Charge) - Disassemble
906K, 906M, 907K, 907M, 908K and 908M Compact Wheel Loaders Window Washer Reservoir - Fill
926M, 930M and 938M Wheel Loaders Power Train Gear Pump (Hydrostatic, Charge) - Remove and Install
D3K2, D4K2 and D5K2 Track-Type Tractor Systems Electronic Control (Winch System)
2014/12/09 Improved Power Train Compartment Oil Level Gauge Assembly Is Now Used on Certain D8R Track-Type Tractors {3016}
D6K2 and D6K Track-Type Tractor Systems Operational Checks
C27 and C32 Engines for Caterpillar Built Machines Data Link - Test
D7E Track-Type Tractor Systems Air Conditioner
621K Wheel Tractor-Scraper Sound Information and Vibration Information
C27 and C32 Engines for Caterpillar Built Machines Data Link Configuration Status - Test
2014/11/03 New Replacement Parts for the Torque Converter Are Now Used on Certain Large Wheel Loaders, Wheel Dozers, and Landfill Compactors {3101, 3105}
926M, 930M and 938M Wheel Loaders Power Train Tire and Rim - Remove and Install
D7E Track-Type Tractor Systems Air Conditioner
Procedure For Updating A 3 Bank Implement Hydraulic System To A 4 Bank Implement Hydraulic System {5051, 5057, 5161, 5170, 5357} Procedure For Updating A 3 Bank Implement Hydraulic System To A 4 Bank Implement Hydraulic System {5051, 5057, 5161, 5170, 5357}
D6R2 Track-Type Tractor Engine Supplement Engine Side Guards - Remove and Install
D6R2 Track-Type Tractor Engine Supplement Fan - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines NRS Exhaust Gas Temperature Is High
C27 and C32 Engines for Caterpillar Built Machines Intake Manifold Air Pressure Is Low