Start By:
- Connect the steering frame lock.
- Release the hydraulic system pressure.
 |
|
Personal injury can result from the sudden release of high pressure oil. Be sure the engine has been shut off for a minimum of five minutes to be sure that the accumulator pressure is zero. The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or cap from the top of the accumulator. A purge screw at the bottom of the accumulator can be used to release the pressure that is left in the system. |
|
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Remove cover (1).
Show/hide table
Illustration 2 g02867549 - Disconnect hose assembly (2).
- Loosen clamps (4) and remove hydrostatic accumulator (3).
Show/hide table
Illustration 3 g02867557 - Remove gas valve cap (5), the gas valve, and the O-ring seals.
| |
| Illustration 1 | g02858296 |
- Install hydrostatic accumulator (3) in the reverse order of removal.
- Tighten gas valve cap (5) to a torque of
1.6 ± 0.1 N·m (14.16 ± 0.89 lb in) .
- Tighten gas valve cap (5) to a torque of