Valve Mechanism Cover - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove clip (3). Remove hose (2). Remove bolts (4). Remove valve mechanism cover (1) .
Show/hide table
Illustration 1 | g01292829 |
- Remove isolation seal (5). Discard isolation seal (5) .
Show/hide table
Illustration 2 | g01292839 |
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Position a new isolation seal (5) onto the valve cover base. Align isolation seal (5) by using the two locator pins.
Show/hide table
Illustration 3 | g01292839 |
- Install valve mechanism cover (1). Install bolts (4). Tighten bolts (4) to a torque of 28 ± 7 N·m (21 ± 5 lb ft).
Show/hide table
Illustration 4 | g01292829 |
- Install hose (2). Install clip (3) .
Caterpillar Information System:
C13 Engine Precooler - Install
C13 Engine Precooler - Remove
G3520C and G3520E Generator Set Engines System Voltage Problem
C13 Engine Turbocharger - Install - Low Pressure
C13 Engine Turbocharger - Remove - Low Pressure
G3520C and G3520E Generator Set Engines Coolant Pressure Is High
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Door Latch
C13 Engine Turbocharger - Install - High Pressure
C13 Engine Turbocharger - Remove - High Pressure
G3520C and G3520E Generator Set Engines Coolant Pressure Is Low
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Door Pull and Retaining Ring
G3520C and G3520E Generator Set Engines Inlet Air Temperature Is High
C13 Engine Cylinder Head - Remove
2006/08/01 New Pressure Sensors Are Now Available {1718, 1917, 1923, 1924}
C175-16 Petroleum Engines Engine Harness
3508B, 3508C, 3512B, 3512C, 3516B and and 3516C Marine Engines Monitoring System
C13 Engine Cylinder Head - Install
C13 Engine Coolant Temperature Sensor - Remove and Install
C13 Engine Inlet Manifold Temperature Sensor - Remove and Install
C13 Engine Inlet Air Temperature Sensor - Remove and Install
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Personal Computer to UPS Connection
2006/10/16 Test Cable Group Checks Three-Wire, Active Analog Circuits That Are Used in Sensors {0779, 0785}
C13 Engine Engine Oil Filter Base and Oil Cooler - Install
C13 Engine Engine Oil Filter Base and Oil Cooler - Remove