C13 Engine Caterpillar

Removal Procedure

Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.

Show/hide table



Illustration 1	g01292479

1. Disconnect harness assembly (1). Remove inlet air temperature sensor (2) .

Installation Procedure

Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.

Show/hide table



Illustration 2	g01292479

1. Install inlet air temperature sensor (2). Tighten inlet air temperature sensor (2) to a torque of 20 ± 3 N·m (15 ± 2 lb ft). Connect harness assembly (1) .