Inlet Manifold Temperature Sensor - Remove and Install
Removal Procedure
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (2). Remove inlet manifold temperature sensor (1) .
Show/hide table
Illustration 1 | g01292468 |
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Install inlet manifold temperature sensor (1). Tighten inlet manifold temperature sensor (1) to a torque of 20 ± 3 N·m (15 ± 2 lb ft). Connect harness assembly (2) .
Show/hide table
Illustration 2 | g01292468 |
Caterpillar Information System:
C13 Engine Coolant Temperature Sensor - Remove and Install
C13 Engine Cylinder Head - Install
3508B, 3508C, 3512B, 3512C, 3516B and and 3516C Marine Engines Monitoring System
C175-16 Petroleum Engines Engine Harness
2006/08/01 New Pressure Sensors Are Now Available {1718, 1917, 1923, 1924}
C13 Engine Cylinder Head - Remove
C13 Engine Valve Mechanism Cover - Remove and Install
C13 Engine Precooler - Install
C13 Engine Precooler - Remove
G3520C and G3520E Generator Set Engines System Voltage Problem
C13 Engine Turbocharger - Install - Low Pressure
C13 Engine Turbocharger - Remove - Low Pressure
C13 Engine Inlet Air Temperature Sensor - Remove and Install
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Personal Computer to UPS Connection
2006/10/16 Test Cable Group Checks Three-Wire, Active Analog Circuits That Are Used in Sensors {0779, 0785}
C13 Engine Engine Oil Filter Base and Oil Cooler - Install
C13 Engine Engine Oil Filter Base and Oil Cooler - Remove
C27 and C32 Generator Set Engines Fuel Priming Pump - Remove and Install
2006/08/01 Improved Support for the Precooler is Now Used {105P, 1380}
C27 and C32 Generator Set Engines Fuel Filter Base - Remove
C27 and C32 Generator Set Engines Fuel Filter Base - Install
C15 and C18 Petrolem Generator Set Engines Symptom Troubleshooting
C27 and C32 Generator Set Engines Fuel Pressure Sensor - Remove and Install
C27 and C32 Generator Set Engines Fuel Temperature Sensor - Remove and Install