Engine Oil Pump - Disassemble
拆解步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | 1P-0510     | 现实型     | 1     |
开始:
- 拆卸发动机机油泵。 请参阅拆解和组装, "发动机机油泵 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 拆下吸油管 (2) 和垫片。 拆下出口弯头 (1) 和 O 形密封圈。
Show/hide table
图 1 | g01026664 |
- 将螺栓 (3) 、垫圈 (4) 和惰轮 (5) 从机油泵上拆下。
Show/hide table
图 2 | g01524205 |
- 利用工具 (A) 和适当的压具将套筒轴承 (8) 从惰轮 (5) 上拆下。
- 将轴 (6) 从油泵壳组件 (7) 上拆下。
Caterpillar Information System:
C7 PETROLEUM Petroleum Engine Electronic Unit Injector Sleeve - Install
C7 PETROLEUM Petroleum Engine Electronic Unit Injector Sleeve - Remove
C7 PETROLEUM Petroleum Engine Crankshaft Rear Seal - Remove
C175-16 and C175-20 Generator Set Engines Fuel Filter (Primary)
C7 Industrial Engines Housing (Front) - Install
C7 Industrial Engines Pistons and Connecting Rods - Install
C7 Industrial Engines Camshaft Bearings - Remove
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
C7 On-Highway Engine Water Pump - Install
C7 On-Highway Engine Water Pump - Remove
C7 PETROLEUM Petroleum Engine Unit Injector Hydraulic Pump - Install
C175-16 Locomotive Engine Engine Design
C7 Industrial Engines Engine Oil Pump - Assemble
C7 On-Highway Engine Front Cover - Remove
C7 On-Highway Engine Front Cover - Install
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies AC Voltage - Calibrate
C7 On-Highway Engine Housing (Front) - Remove
C175 Generator Sets Walk-Around Inspection
C175-16 and C175-20 Generator Set Engines Fuel Transfer Pump
C7 On-Highway Engine Housing (Front) - Install
SR5 Electric Power Generation Rotor - Remove and Install
C7 On-Highway Engine Camshaft Idler Gear - Remove and Install
SR5 Electric Power Generation Generator - Remove
SR5 Electric Power Generation Generator - Install