Electronic Unit Injector Sleeve - Install
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
B     | 221-9777     | 套管安装工具     | 1     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将新 O 形密封圈 (2) 安装到电子单体喷油器套筒 (1) 上。
Show/hide table
图 1 | g01025481 |
- 将电子单体喷油器套筒 (1) 放到工具 (B) 上。
- 利用洁净的机油润滑新 O 形密封圈,并将电子单体喷油器套筒定位到缸盖内。
- 利用手锤将电子单体喷油器套筒 (1) 安装到缸盖内。
- 向冷却系统加注冷却液。 关于冷却系统容量,请参阅操作和保养手册, "加注容量"。
End By: 安装电子单体喷油器。 请参阅 拆解和组装, "电子单体喷油器 - 安装"。
Caterpillar Information System:
C7 PETROLEUM Petroleum Engine Electronic Unit Injector Sleeve - Remove
C7 PETROLEUM Petroleum Engine Crankshaft Rear Seal - Remove
C175-16 and C175-20 Generator Set Engines Fuel Filter (Primary)
C7 Industrial Engines Housing (Front) - Install
C7 Industrial Engines Pistons and Connecting Rods - Install
C7 Industrial Engines Camshaft Bearings - Remove
C7 On-Highway Engine Vibration Damper and Pulley - Remove and Install
C7 On-Highway Engine Water Pump - Install
C7 On-Highway Engine Water Pump - Remove
C7 PETROLEUM Petroleum Engine Unit Injector Hydraulic Pump - Install
C175-16 Locomotive Engine Engine Design
C7 PETROLEUM Petroleum Engine Unit Injector Hydraulic Pump - Remove
C7 PETROLEUM Petroleum Engine Engine Oil Pump - Disassemble
C7 Industrial Engines Engine Oil Pump - Assemble
C7 On-Highway Engine Front Cover - Remove
C7 On-Highway Engine Front Cover - Install
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies AC Voltage - Calibrate
C7 On-Highway Engine Housing (Front) - Remove
C175 Generator Sets Walk-Around Inspection
C175-16 and C175-20 Generator Set Engines Fuel Transfer Pump
C7 On-Highway Engine Housing (Front) - Install
SR5 Electric Power Generation Rotor - Remove and Install
C7 On-Highway Engine Camshaft Idler Gear - Remove and Install
SR5 Electric Power Generation Generator - Remove