Camshaft Idler Gear - Remove and Install
Start By:
- Remove the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Remove".
- Note the position of the timing marks on the idler gear for assembly purposes. Remove bolts (1). Remove retaining plate (2).
Show/hide table
Illustration 2 g01263192 - Remove idler gear (3).
Show/hide table
Illustration 3 g01263194 - Remove bolt (4). Remove shaft (5) and thrust plate (6).
Show/hide table
Illustration 1 | g01263191 |
- Install thrust plate (6) and shaft (5). Install bolt (4).
Show/hide table
Illustration 5 g01263192 - Align the timing marks on idler gear (3) with the mark on the crankshaft gear. Install idler gear (3).
Show/hide table
Illustration 6 g01263191 - Install retaining plate (2). Install bolts (1). Tighten bolts (1) to a torque of
70 ± 15 N·m (52 ± 11 lb ft) .
Show/hide table
Illustration 4 | g01263194 |
End By:
- Install the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Install".
Caterpillar Information System:
SR5 Electric Power Generation Rotor - Remove and Install
C7 On-Highway Engine Housing (Front) - Install
C175-16 and C175-20 Generator Set Engines Fuel Transfer Pump
C175 Generator Sets Walk-Around Inspection
C7 On-Highway Engine Housing (Front) - Remove
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies AC Voltage - Calibrate
C7 On-Highway Engine Front Cover - Install
C7 On-Highway Engine Front Cover - Remove
C7 Industrial Engines Engine Oil Pump - Assemble
C7 PETROLEUM Petroleum Engine Engine Oil Pump - Disassemble
C7 PETROLEUM Petroleum Engine Electronic Unit Injector Sleeve - Install
C7 PETROLEUM Petroleum Engine Electronic Unit Injector Sleeve - Remove
SR5 Electric Power Generation Generator - Remove
SR5 Electric Power Generation Generator - Install
SR5 Electric Power Generation Generator - Align
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies AC Output Current - Calibrate
SR5 Electric Power Generation Coupling - Remove
SR5 Electric Power Generation Coupling - Install
SR5 Electric Power Generation Bearing - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Event Code List
CX31-P600 Petroleum Transmission Speed Sensor (Transmission)
2006/06/12 Improved Elbows are Used for Inlet Air {1071}
BA-921 Bendix Air Compressor Unloader Piston - Install
BA-921 Bendix Air Compressor Unloader Piston - Remove