Housing (Front) - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 8T-9011 | Component Cleaner | 1 |
B | 4C-9500 | Quick Cure Primer | 1 |
C | 1U-8846 | Sealant | 1 |
\
- Clean the joint face on front housing (4) with Tooling (A).
- Apply Tooling (B) to the joint face. Allow the primer to dry for at least three to five minutes.
Show/hide table
Illustration 2 g01351898 Note: Ensure that the groove for the oil supply is not blocked by excess sealant.
- Apply Tooling (C) in a bead with a width of
3.0 ± 0.5 mm (0.12 ± 0.02 inch) to the joint face. Refer to Illustration 2. Spread the sealant uniformly. Front housing (4) must be installed within ten minutes of applying the sealant. - Position front housing (4) on the cylinder block.
Show/hide table
Illustration 3 g01263145 - Install bolts (1). Install bolts (2) and (3).
Show/hide table
Illustration 1 | g01263148 |
End By:
- Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".
- Install the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Install".
- Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
- Install the fuel filter base. Refer to Disassembly and Assembly, "Fuel Filter Base - Remove and Install".
Caterpillar Information System:
C175-16 and C175-20 Generator Set Engines Fuel Transfer Pump
C175 Generator Sets Walk-Around Inspection
C7 On-Highway Engine Housing (Front) - Remove
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies AC Voltage - Calibrate
C7 On-Highway Engine Front Cover - Install
C7 On-Highway Engine Front Cover - Remove
C7 Industrial Engines Engine Oil Pump - Assemble
C7 PETROLEUM Petroleum Engine Engine Oil Pump - Disassemble
C7 PETROLEUM Petroleum Engine Electronic Unit Injector Sleeve - Install
C7 PETROLEUM Petroleum Engine Electronic Unit Injector Sleeve - Remove
C7 PETROLEUM Petroleum Engine Crankshaft Rear Seal - Remove
C175-16 and C175-20 Generator Set Engines Fuel Filter (Primary)
SR5 Electric Power Generation Rotor - Remove and Install
C7 On-Highway Engine Camshaft Idler Gear - Remove and Install
SR5 Electric Power Generation Generator - Remove
SR5 Electric Power Generation Generator - Install
SR5 Electric Power Generation Generator - Align
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies AC Output Current - Calibrate
SR5 Electric Power Generation Coupling - Remove
SR5 Electric Power Generation Coupling - Install
SR5 Electric Power Generation Bearing - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Event Code List
CX31-P600 Petroleum Transmission Speed Sensor (Transmission)
2006/06/12 Improved Elbows are Used for Inlet Air {1071}