Flywheel Housing - Remove and Install
拆卸步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 138-7574     | 连杆支架     | 2     |
B     | -     | 导向双头螺柱 1/2 - 13 NC x 7 in     |
2     |
开始:
- 拆下曲轴后密封。 请参阅拆解和组装, "曲轴后密封 - 拆卸"。
- 拆下电起动马达。 请参阅拆解和组装, "电起动马达 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将软管组件 (1) 从飞轮壳 (2) 上断开。
Show/hide table
图 1 | g01220951 |
- 将燃油滤清器底座 (5) 从飞轮壳 (2) 上断开。 重新定位燃油滤清器底座 (5) 和软管组件。
- 拆下两个螺栓 (4) 并安装工具 (B) 。
- 将工具 (A) 和适当的起吊设备连接到飞轮壳 (2) 上。 飞轮壳体 (2) 的重量约为 110 kg (245 lb)。
- 拆下其余螺栓 (4) 、螺栓 (6) 和螺栓 (3) 。 从后壳体上卸下飞轮壳 (2) 和密封垫。
安装步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 138-7574     | 连杆支架     | 2     |
B     | -     | 导向双头螺柱 1/2 - 13 NC x 7 in     |
2     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将工具 (B) 安装到缸体中。
Show/hide table
图 2 | g01220951 |
Show/hide table
图 3 | g01221009 |
- 将工具 (A) 和适当的起吊设备连接到飞轮壳 (2) 上。 飞轮壳体 (2) 的重量约为 110 kg (245 lb)。
- 将密封垫和飞轮壳 (2) 定位到后壳体上。 安装螺栓 (3) 、 (6) 和 (4) 。
- 拆下工具 (B) ,然后安装其余的螺栓 (4) 。
- 按照下列步骤拧紧螺栓:
- 按照数字顺序依次拧紧螺栓 1 到螺栓 2 至扭矩为 55 ± 10 N·m (41 ± 7 lb ft)。
- 按照数字顺序依次拧紧螺栓 3 到螺栓 10 至扭矩为 135 ± 20 N·m (100 ± 15 lb ft)。
- 按照数字顺序依次拧紧螺栓 11 到螺栓 36 至扭矩为 47 ± 9 N·m (35 ± 7 lb ft)。
- 重新定位燃油滤清器底座 (5) 和软管组件。 将燃油滤清器底座 (5) 连接到飞轮壳 (2) 上。
- 将软管组件 (1) 连接到飞轮壳 (2) 上。
End By:
- 安装电起动马达。 请参阅 拆解和组装, "电起动马达 - 拆卸和安装"。
- 安装曲轴后密封。 请参阅 拆解和组装, "曲轴后油封 - 安装"。
Caterpillar Information System:
C7 Urban Transit Bus Engines Monitoring System
2005/11/14 New Aftercoolers are Now Used {1063}
2011/11/16 A New Connecting Rod Is Used in 3500B and 3500C High Displacement Engines {1218}
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Electronic Modular Control Panel 3 (EMCP 3)
C27 and C32 Generator Set Engines Crankshaft Rear Seal - Install
C27 and C32 Generator Set Engines Crankshaft Rear Seal - Remove
C15 and C18 Petroleum Engines Engine Oil Pan
C27 and C32 Generator Set Engines Flywheel - Remove and Install
320D and 323D Excavators Machine System Specifications Front Lines
C7 Urban Transit Bus Engines Exhaust Particulate Filter Indicator - Check - Diesel Particulate Filter (DPF) Diagnostic Module
Inspecting the Turbocharger for Exhaust Leaks{1052} Inspecting the Turbocharger for Exhaust Leaks{1052}
C15 and C18 Industrial Engines Engine Oil Pan
C15-XQ400 Rental Generator Set Plate Locations and Film Locations
C15 and C18 Industrial Engines Vibration Damper
2005/12/12 New Flash File on C18 Marine Engines {7620}
330D and 336D Excavators Leaving the Machine
C175 Generator Set Engines Flywheel Housing - Install
C27 and C32 Generator Set Engines Vibration Damper and Pulley - Remove and Install
C15-XQ400 Rental Generator Set Setup
C32 Petroleum Generator Sets Generator Operation
TH31-E61 and TH35-E81 Petroleum Transmissions Lubricant Viscosities
CX35 On-Highway Transmission Oil Filter (Transmission) - Replace
C175 Generator Set Engines Engine Oil Pan - Install
C27 and C32 Generator Set Engines Crankshaft Front Seal - Remove