Engine Oil Filter Base - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position engine oil filter base (3) on the engine. Install bolts (1) and washers (2).
- Connect hose assemblies (4) and (5).
- Install engine oil filters (6).
- Fill the lubrication system with engine oil. Refer to Operation and Maintenance Manual, "Refill Capacities".
Show/hide table
Illustration 1 | g01200313 |
Caterpillar Information System:
3406C Engines for Caterpillar Built Machines Engine Oil Filter Base
C32 Petroleum Engines Engine Oil Filter Base - Remove
C175 Generator Set Engines Crankshaft Rear Seal - Remove
C175-16 and C175-20 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
C6.6 Engines for Caterpillar Built Machines Electrical System
C7.1 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
C6.6 Engines for Caterpillar Built Machines Air in Fuel - Test
C7.1 Engines for Caterpillar Built Machines Gear Group (Front) - Time
2007/02/26 Improved Wiring Schematics for the Governor Control {1264, 7566}
C32 Petroleum Engines Exhaust Manifold - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Upper Frame and Undercarriage Frame - Separate
C175 Generator Set Engines Crankshaft Rear Seal - Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Disassemble
C15 Generator Set Engines Cat Data Link Circuit - Test
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Assemble
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Remove
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Install
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Disassemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove
C15 Generator Set Engines Speed Control (Switch) - Test