Engine Oil and Water Pump Drive - Disassemble
拆解步骤
开始:
- 拆卸发动机机油和水泵驱动器。 参考拆解与组装, "发动机机油和水泵驱动器 - 拆卸"。
- 拆下螺栓 (1) 。
Show/hide table
 | |
| 图 1 | g01200678 |
- 拆卸隔套 (2) 、齿轮 (3) 和泵驱动轴 (4) 。
Show/hide table
 | |
| 图 2 | g01200684 |
Caterpillar Information System:
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Install
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Assemble
C15 Generator Set Engines Cat Data Link Circuit - Test
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Disassemble
C175 Generator Set Engines Crankshaft Rear Seal - Install
C32 Petroleum Engines Engine Oil Filter Base - Install
3406C Engines for Caterpillar Built Machines Engine Oil Filter Base
C32 Petroleum Engines Engine Oil Filter Base - Remove
C175 Generator Set Engines Crankshaft Rear Seal - Remove
C175-16 and C175-20 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove
C15 Generator Set Engines Speed Control (Switch) - Test
C11 and C13 Engines for Caterpillar Built Machines Low Engine Oil Pressure Lamp Circuit - Test
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Mode Switch Setup
C6.6 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C175 Generator Set Engines Engine Oil Filter Housing - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Install
C6.6 Engines for Caterpillar Built Machines Power Sources
C7.1 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Recoil Spring - Disassemble