Crankshaft Rear Seal - Install
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
C     | 250-4587     | 安装工具     | 1     |
250-4586 | 定位工具     | 1     | |
322-2078 | 螺栓     | 2     | |
9S-8858 | 螺母     | 1     |
- 利用工具 (C) 安装曲轴后油封 (1) 。
注: 安置定位器并用螺栓固定到位。 将密封安装在定位器上并安置安装工具。 安装螺母并将其转动到最大限度。 检查并拆卸工具。
Show/hide table
图 1 | g01200381 |
End By: 安装飞轮。 参考 拆解和组装, "飞轮 - 拆卸和安装"。
Caterpillar Information System:
C32 Petroleum Engines Engine Oil Filter Base - Install
3406C Engines for Caterpillar Built Machines Engine Oil Filter Base
C32 Petroleum Engines Engine Oil Filter Base - Remove
C175 Generator Set Engines Crankshaft Rear Seal - Remove
C175-16 and C175-20 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
C6.6 Engines for Caterpillar Built Machines Electrical System
C7.1 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
C6.6 Engines for Caterpillar Built Machines Air in Fuel - Test
C7.1 Engines for Caterpillar Built Machines Gear Group (Front) - Time
2007/02/26 Improved Wiring Schematics for the Governor Control {1264, 7566}
C32 Petroleum Engines Exhaust Manifold - Remove and Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Disassemble
C15 Generator Set Engines Cat Data Link Circuit - Test
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Assemble
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Remove
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Install
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Disassemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Install
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove
C15 Generator Set Engines Speed Control (Switch) - Test
C11 and C13 Engines for Caterpillar Built Machines Low Engine Oil Pressure Lamp Circuit - Test