Engine Oil and Water Pump Drive - Install
安装步骤
- 安装发动机机油和水泵驱动器 (6) 。
Show/hide table
图 1 | g01200652 |
- 使用工具 (A) 和适当的压具将轴承 (5) 安装到盖 (2) 中。
Show/hide table
图 2 | g01200650 |
- 安装 O 形密封圈 (3) 和 (4) 。
Show/hide table
图 3 | g01200648 |
注: 检查 O 形密封圈有无磨损或损坏。 如有必要,更换 O 形密封圈。
- 安置盖 (2) 。 安装螺栓 (1) 。
Show/hide table
图 4 | g01200542 |
End By: 安装发动机机油泵。 请参阅 拆解和组装, "发动机机油泵 - 安装"。
Caterpillar Information System:
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Disassemble
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Install
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil and Water Pump Drive - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Track Carrier Roller - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Assemble
C15 Generator Set Engines Cat Data Link Circuit - Test
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Disassemble
C175 Generator Set Engines Crankshaft Rear Seal - Install
C32 Petroleum Engines Engine Oil Filter Base - Install
3406C Engines for Caterpillar Built Machines Engine Oil Filter Base
C32 Petroleum Engines Engine Oil Filter Base - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove
C15 Generator Set Engines Speed Control (Switch) - Test
C11 and C13 Engines for Caterpillar Built Machines Low Engine Oil Pressure Lamp Circuit - Test
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Mode Switch Setup
C6.6 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C175 Generator Set Engines Engine Oil Filter Housing - Remove
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Install
C6.6 Engines for Caterpillar Built Machines Power Sources
C7.1 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Recoil Spring - Disassemble
C32 Petroleum Engines Engine Oil Filter Base - Disassemble
C32 Petroleum Engines Engine Oil Filter Base - Assemble