Pressure Protection Valve (Brake Air System)
Show/hide table
Illustration 1 | g00293032 |
The pressure protection valve is normally in a CLOSED position.
- The following pressure is the maximum operating pressure. ... 1034 kPa (150 psi)
- The following pressure is needed to open the valve. ... 517 + 68 - 0 kPa (75 + 10 - 0 psi)
- The following pressure is needed to close the valve. ... 413 + 34 - 0 kPa (60 + 5 - 0 psi)
- The following pressure is needed to open the valve. ... 517 + 68 - 0 kPa (75 + 10 - 0 psi)
Caterpillar Information System:
615C Series II Wheel Tractor-Scraper Air System and Brakes Differential Lock Control
611 and 615C Series II Wheel Tractor-Scrapers Steering System Steering System Troubleshooting
611 and 615C Series II Wheel Tractor-Scrapers Steering System Piston Pump (Secondary Steering)
611 and 615C Series II Wheel Tractor-Scrapers Steering System General Information
938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Pilot Operated Hydraulic Control - Assemble
938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Pilot Operated Hydraulic Control - Disassemble
651E and 657E Wheel Tractor-Scrapers Hydraulic System Relief Valve (Push-Pull) - Test and Adjust
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Bucket Wear Plates - Inspect/Replace
C7 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
C7 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
2003/04/07 An Improved Cooling Fan Clutch Is Now Used For D9R and D10R {1359}
C11 and C13 Engines for Caterpillar Built Machines Variable Valve Actuators - Inspect/Adjust
2003/10/27 Special Instruction, REHS1522 , "Instruction Book for the Lincoln Quicklub® Automatic Lubrication System for the 988G Model Wheel Loaders" is Available {7540}
C7 Engines for Caterpillar Built Machines Camshaft Gear - Remove and Install
980G Series II Wheel Loader Electrohydraulic System Hydraulic Fan Speed - Test and Adjust
Support literature for the Lincoln Industrial Quicklub System for the 988G Wheel Loader{7540} Support literature for the Lincoln Industrial Quicklub System for the 988G Wheel Loader{7540}
2003/03/24 New Flash Software Allows Calibrations of the Power Train to be Performed by Using the Caterpillar Electronic Technician {0783, 0785, 7620}
C4.4 (Mech) Industrial Engine Battery - Test
C15 Petroleum Generator Set Engines Electronic Unit Injector Rocker Arm
3046 Engine for Caterpillar Built Machines Flywheel Housing - Inspect
2003/06/23 Correction to Testing And Adjusting , "Transmission Testing and Location of The Pressure Taps" {3030, 3073}
2003/04/21 Correction to Testing and Adjusting , "Pressure Tap Locations" {3030}
C7 Engines for Caterpillar Built Machines Unit Injector - Remove
C7 Engines for Caterpillar Built Machines Unit Injector - Install