Position Sensor (Control Lever)
Show/hide table
Illustration 1 | g00636653 |
106-4437 Position Sensor
Show/hide table
Wiring Table     | ||
Pin     | Nomenclature of Circuit     | Wire Color     |
A     | +Battery     | Red     |
B     | Ground     | Black     |
C     | Signal     | Yellow     |
Operating supply voltage ... 9 to 32 V
Temperature range ... -40 to 85 °C (-40 to 185 °F)
Maximum current requirement ... 30 mA
Output frequency
- Minimum ... 4273 Hz
- Nominal ... 5128 Hz
- Maximum ... 6410 Hz
- Nominal ... 5128 Hz
Output (Low Voltage)
- Maximum ... 1 V
Output (High Voltage)
- Minimum ... 3.5 V
- Maximum ... 5.5 V
Maximum current sink capability ... 9 mA
Maximum current source capability ... 0 mA
161-8979 Position Sensor
Show/hide table
Wiring Table     | ||
Pin     | Nomenclature of Circuit     | Wire Color     |
A     | +Battery     | Orange     |
B     | Ground     | Black     |
C     | Signal     | White     |
Operating supply voltage ... 9 to 32 V
Temperature range ... -40 to 85 °C (-40 to 185 °F)
Maximum current requirement ... 30 mA
Output Frequency
- Nominal 100 Hz ... Range 70 to 150 Hz
- Nominal 500 Hz ... Range 350 to 700 Hz
- Nominal 5 kHz ... Range 3.8 to 6.7 kHz
- Nominal 500 Hz ... Range 350 to 700 Hz
Output (Low Voltage)
- Maximum ... 1 V
Output (High Voltage) ... at rated source current
Maximum current sink capability ... 9 mA
Maximum current source capability ... 0 mA
Caterpillar Information System:
3056 Engine for Caterpillar Built Machines Turbocharger - Install
3056 Engine for Caterpillar Built Machines Lubrication System
992G, 992K, 994, 994D and 994F Wheel Loaders VIMS Loader Payload System Payload Memory Capacity
C9 Engine For Caterpillar Built Machines Injection Actuation Pressure Sensor - Remove and Install
902 and 906 Compact Wheel Loaders Machine Systems Window Wiper Motor (Rear) - Install
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Fuel Filter Differential Pressure Switch
615C Series II Wheel Tractor-Scraper Air System and Brakes General Information
631E Series II, 633E Series II and 637E Series II Wheel Tractor Power Train Differential and Bevel Gear - Adjust
908 Compact Wheel Loader Hydraulic System Solenoid Valve and Mounting (Pilot Shutoff)
C9 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
908 Compact Wheel Loader Hydraulic System Accumulator (Pilot Oil)
824G , 825G and 826G Landfill Compactor Sampling Interval and Location of Sampling Valve
631E Series II, 633E Series II and 637E Series II Wheel Tractor Power Train General Testing and Adjusting Information
3056 Engine for Caterpillar Built Machines Exhaust Manifold - Remove and Install
3500 Generator Sets Voltage and Frequency - Check
3056 Engine for Caterpillar Built Machines Air Inlet Manifold - Remove
992G Wheel Loader and 854G Wheel Dozer Steering System Articulated Hitch
908 Compact Wheel Loader Hydraulic System Pilot Valve (Joystick)
908 Compact Wheel Loader Hydraulic System Gear Motor (Fan)
C9 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
3056 Engine for Caterpillar Built Machines Air Inlet Manifold - Install
908 Compact Wheel Loader Hydraulic System Lift Cylinder
908 Compact Wheel Loader Hydraulic System Tilt Cylinder
908 Compact Wheel Loader Hydraulic System Coupler Cylinder