Turbocharger - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of all gaskets. Replace the gaskets, if necessary.
- Install turbocharger (1) and the gasket.
Show/hide table
Illustration 1 | g00636534 |
- Install four nuts (10) .
- Slide hose over the turbocharger outlet and install hose clamp (9) .
- Apply 5P-3931 Anti-Seize Compound to nuts (10) that are used to mount the turbocharger. Tighten the nuts to a torque of 44 N·m (33 lb ft).
- Install the gasket and oil supply line (3) to the oil filter base. Tighten flare nut (8) .
Show/hide table
Illustration 2 | g00636533 |
- Install the hose and hose clamp (7) for the oil return line (5) .
- Install two bolts (2) for oil supply line (3) on turbocharger (1) .
Show/hide table
Illustration 3 | g00636505 |
- Install two bolts (4) for oil return line (5) on turbocharger (1) .
- Install the bolt (6) and clamps that hold oil supply line (3) and oil return line (5) to the cylinder block.
Show/hide table
Illustration 4 | g00639389 |
Caterpillar Information System:
3056 Engine for Caterpillar Built Machines Lubrication System
992G, 992K, 994, 994D and 994F Wheel Loaders VIMS Loader Payload System Payload Memory Capacity
C9 Engine For Caterpillar Built Machines Injection Actuation Pressure Sensor - Remove and Install
902 and 906 Compact Wheel Loaders Machine Systems Window Wiper Motor (Rear) - Install
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Fuel Filter Differential Pressure Switch
615C Series II Wheel Tractor-Scraper Air System and Brakes General Information
631E Series II, 633E Series II and 637E Series II Wheel Tractor Power Train Differential and Bevel Gear - Adjust
908 Compact Wheel Loader Hydraulic System Solenoid Valve and Mounting (Pilot Shutoff)
C9 Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor - Remove and Install
908 Compact Wheel Loader Hydraulic System Accumulator (Pilot Oil)
824G , 825G and 826G Landfill Compactor Sampling Interval and Location of Sampling Valve
3056 Engine for Caterpillar Built Machines Fuel Injection Pump - Install
980G Wheel Loader Hydraulic System Position Sensor (Control Lever)
631E Series II, 633E Series II and 637E Series II Wheel Tractor Power Train General Testing and Adjusting Information
3056 Engine for Caterpillar Built Machines Exhaust Manifold - Remove and Install
3500 Generator Sets Voltage and Frequency - Check
3056 Engine for Caterpillar Built Machines Air Inlet Manifold - Remove
992G Wheel Loader and 854G Wheel Dozer Steering System Articulated Hitch
908 Compact Wheel Loader Hydraulic System Pilot Valve (Joystick)
908 Compact Wheel Loader Hydraulic System Gear Motor (Fan)
C9 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor - Remove and Install
3056 Engine for Caterpillar Built Machines Air Inlet Manifold - Install
908 Compact Wheel Loader Hydraulic System Lift Cylinder
908 Compact Wheel Loader Hydraulic System Tilt Cylinder