Work Tool Lift Control
Show/hide table
|
|
|
Illustration 1 | g00610226 |
Show/hide table
| FLOAT (1) - Push the lift lever forward into the detent. The work tool will lower to the ground. The work tool will float with the contour of the ground. |
The lift lever will remain in the FLOAT position until the lift lever is pulled out of the detent. The lift lever will return to the HOLD position when the lift lever is released.
Show/hide table
|
NOTICE |
Never use the FLOAT position to lower a loaded bucket. Machine damage can result from a bucket that falls too fast. |
|
Show/hide table
| LOWER (2) - Push the lift lever forward in order to lower the work tool. The lift lever will return to the HOLD position when the lift lever is released. |
Show/hide table
| HOLD (3) - The lift lever will return to the HOLD position when the lift lever is released from the RAISE position or from the LOWER position. The work tool will remain in the selected position. |
Show/hide table
| RAISE (4) - Pull the lift lever backward in order to raise the work tool. Release the lift lever in order to stop lifting the work tool. The lift lever will return to the HOLD position when the lift lever is released. |
The lift lever is detented in the fully raised position (5). The lift lever will stay in the detent and the work tool will continue to rise until the work tool reaches the lift kickout height. Then, the lift lever will return to the HOLD position.
Work Tool Tilt Control
Show/hide table
|
|
|
Illustration 2 | g00610227 |
Show/hide table
| DUMP (1) - Push the tilt lever to this position in order to tilt the work tool. |
Show/hide table
| HOLD (2) - When you release the tilt lever, the tilt lever will return to the HOLD position. The work tool will remain in the selected position. |
Show/hide table
| TILT BACK (3) - Push the tilt lever to this position in order to tilt the work tool backward. |
The joystick control is detented in the maximum tilt back position. The joystick control will stay in the detent and the work tool will continue to tilt back until the work tool reaches the preset location for the tilt kickout. Then, the joystick control will return to the HOLD position.