Gear Pump (Implement Pilot) - Install
- Check the condition of the O-ring seals on the ends of the hose assemblies. If either of the O-ring seals is damaged, use new parts for replacement.
Show/hide table
Illustration 1 g00400110 - Install coupling (6) on the pump drive.
Show/hide table
Illustration 2 g00400107 - Install O-ring seal (5) on the pilot pump.
Show/hide table
Illustration 3 g00400104 - Install pilot pump (2) and bolts (4).
Show/hide table
Illustration 4 g00400102 - Install two hose assemblies (3).
Show/hide table
Illustration 5 g00400100 - Close platform door (1).
- Fill the implement hydraulic tank with oil. For the correct procedure, refer to the Operation and Maintenance Manual for your machine.
- Start the engine and check for leaks. Check for proper operation of the implement hydraulics.
End By:
- Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Caterpillar Information System:
854G Wheel Dozer Machine Systems Gear Pump (Implement Pilot) - Remove
627F Wheel Tractor-Scraper Cooling System Coolant (ELC) - Change
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake - Install
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake - Remove
994D Wheel Loader Power Train Modulating Valve (Torque Converter Impeller Clutch)
953C, 963C and 973C Track-Type Loaders Transmission Electronic Control System Electronic Control Module (ECM) - Replace
D6G Track-Type Tractor Power Train Recoil Spring - Disassemble
613C Series II Wheel Tractor-Scraper Machine Systems Parking Brake Actuator - Assemble
994D Wheel Loader Power Train Speed Sensor (Torque Converter Output)
D6G Track-Type Tractor Power Train Recoil Spring - Remove and Install
D6G Track-Type Tractor Power Train Hydraulic Track Adjusters - Assemble
Field Installation of Decelerator Pedal{1276} Field Installation of Decelerator Pedal{1276}
D6G Track-Type Tractor Power Train Recoil Spring - Assemble
613C Series II Wheel Tractor-Scraper Machine Systems Vane Motor (Elevator) - Remove
966G Wheel Loader and 972G Wheel Loader Machine Systems Pilot Valve (Oil Manifold) - Remove
D6G Track-Type Tractor Power Train Track Roller Frame - Remove
994D Wheel Loader Power Train Modulating Valve (Torque Converter Lockup Clutch)
966G Wheel Loader and 972G Wheel Loader Machine Systems Pilot Valve (Oil Manifold) - Install
613C Series II Wheel Tractor-Scraper Machine Systems Vane Motor (Elevator) - Install
D6G Track-Type Tractor Power Train Track Roller Frame - Install
854G Wheel Dozer Machine Systems Tilt Control Valve (Dual) - Remove
966G Wheel Loader and 972G Wheel Loader Machine Systems Pilot Valve (Oil Manifold) - Disassemble
966G Wheel Loader and 972G Wheel Loader Machine Systems Pilot Valve (Oil Manifold) - Assemble
854G Wheel Dozer Machine Systems Stabilizer Link - Remove and Install