Engine Control Module - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the negative battery terminal at the battery.
Show/hide table
Illustration 1 g01080613 - Loosen allen head screw (1). Disconnect the harness assembly from engine control module (2).
- Remove studs (3). Remove the engine control module, the washers, and the isolation mounts.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position the isolation mounts, spacers, electronic control module (2) and ground strap (4) and install bolts (3).
- Connect the harness assembly to the engine control module and tighten allen head screw (1).
- Connect the negative battery terminal at the battery.
Show/hide table
Illustration 2 | g01080551 |
Caterpillar Information System:
3126B Petroleum Engine E040 Low Engine Oil Pressure Shutdown
3126B Petroleum Engine E039 Low Engine Oil Pressure Derate
3126B Petroleum Engine E027 High Inlet Air Temperature Warning
3126B Petroleum Engine E025 High Inlet Air Temperature Derate
C7 Marine Engines Electric Starting Motor - Remove and Install
C7 Marine Engines Alternator - Remove and Install
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Modem
C7 Marine Engines Electronic Control Module - Remove and Install
C7 Marine Engines Crankshaft Gear - Remove and Install
G3500B Engines Auxiliary Water Pump
G3500 A3 Engines Engine Shutdown
C-10 and C-15 Petroleum Engines Intermittent Engine Shutdown
C-10 and C-15 Petroleum Engines E054 High Fuel Temperature Derate
C-10 and C-15 Petroleum Engines E055 High Fuel Temperature Shutdown
C-10 and C-15 Petroleum Engines E056 High Fuel Temperature Warning
C-10 and C-15 Petroleum Engines E443 High Auxiliary Pressure
C-10 and C-15 Petroleum Engines E445 High Auxiliary Temperature
C-10 and C-15 Petroleum Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
C15 On-highway Engines Fuel Filter Base - Remove
C11 and C15 Engines for Caterpillar Built Machines CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
C15 On-highway Engines Fuel Filter Base - Install
C11 and C15 Engines for Caterpillar Built Machines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
3126B Petroleum Engine Air Shutoff System - Test
Guidelines for the Use of High Efficiency Filters for the Hydraulic Oil System and for the Power Train Oil System {3000, 3004, 5050, 5068} Guidelines for the Use of High Efficiency Filters for the Hydraulic Oil System and for the Power Train Oil System {3000, 3004, 5050, 5068}