Electric Starting Motor - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the battery cables from the battery.
- Place an index mark on all of the harness assemblies that are connected to the electric starting motor. Disconnect the harness assemblies from the electric starting motor.
- Fasten a suitable lifting device to electric starting motor (2). The weight of the electric starting motor is approximately 27 kg (60 lb).
Show/hide table
Illustration 1 | g01081077 |
- Remove bolts (1) .
- Remove electric starting motor (2) .
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Fasten a suitable lifting device to electric starting motor (2). The weight of the electric starting motor is approximately 27 kg (60 lb).
Show/hide table
Illustration 2 | g01081077 |
- Position the electric starting motor in the flywheel housing. Install bolts (1) .
- Connect all of the harness assemblies to the electric starting motor by using the index marks.
- Connect the battery cables to the battery.
Caterpillar Information System:
C7 Marine Engines Alternator - Remove and Install
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Modem
C7 Marine Engines Electronic Control Module - Remove and Install
C7 Marine Engines Crankshaft Gear - Remove and Install
G3500B Engines Auxiliary Water Pump
G3500 A3 Engines Engine Shutdown
C-10 and C-15 Petroleum Engines Intermittent Engine Shutdown
2004/07/01 Internal Components for Remanufactured Injectors are Now Coated for Increased Service Life {1290}
3126B Petroleum Engine Exhaust Temperature Is Too High
C13, C15, and C18 Generator Set Engines Excessive Black Smoke
C27 and C32 Industrial and Petroleum Engines Engine Will Not Crank
3126B Petroleum Engine Engine Stalls at Low RPM
3126B Petroleum Engine E025 High Inlet Air Temperature Derate
3126B Petroleum Engine E027 High Inlet Air Temperature Warning
3126B Petroleum Engine E039 Low Engine Oil Pressure Derate
3126B Petroleum Engine E040 Low Engine Oil Pressure Shutdown
C15 On-highway Engines Engine Control Module - Remove and Install
C-10 and C-15 Petroleum Engines E054 High Fuel Temperature Derate
C-10 and C-15 Petroleum Engines E055 High Fuel Temperature Shutdown
C-10 and C-15 Petroleum Engines E056 High Fuel Temperature Warning
C-10 and C-15 Petroleum Engines E443 High Auxiliary Pressure
C-10 and C-15 Petroleum Engines E445 High Auxiliary Temperature
C-10 and C-15 Petroleum Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
C15 On-highway Engines Fuel Filter Base - Remove