Fuel Filter Base - Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position fuel filter base (4) on the cylinder block. Install bolts (1).
- Install fuel filter (7) on the fuel filter base. Follow the directions on the fuel filter for the correct installation procedure. Do not overtighten the fuel filter.
- Connect hose assembly (3) to the fuel filter base.
- Connect hose assembly (5) to the fuel filter base.
- Connect tube assembly (6) to the fuel filter base.
- Install fuel pressure sensor (3). Connect the harness assembly to the fuel pressure sensor.
- Turn the fuel supply to the “ON” position.
- Remove the air from the system. Refer to Testing and Adjusting, "Fuel System - Prime".
Show/hide table
| |
| Illustration 1 | g01080654 |
Caterpillar Information System:
C11 and C15 Engines for Caterpillar Built Machines CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
C15 On-highway Engines Fuel Filter Base - Remove
C-10 and C-15 Petroleum Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
C-10 and C-15 Petroleum Engines E445 High Auxiliary Temperature
C-10 and C-15 Petroleum Engines E443 High Auxiliary Pressure
C-10 and C-15 Petroleum Engines E056 High Fuel Temperature Warning
C-10 and C-15 Petroleum Engines E055 High Fuel Temperature Shutdown
C-10 and C-15 Petroleum Engines E054 High Fuel Temperature Derate
C15 On-highway Engines Engine Control Module - Remove and Install
3126B Petroleum Engine E040 Low Engine Oil Pressure Shutdown
3126B Petroleum Engine E039 Low Engine Oil Pressure Derate
3126B Petroleum Engine E027 High Inlet Air Temperature Warning
C11 and C15 Engines for Caterpillar Built Machines CID 0262 FMI 04 5 Volt Sensor DC Power Supply short to ground
3126B Petroleum Engine Air Shutoff System - Test
Guidelines for the Use of High Efficiency Filters for the Hydraulic Oil System and for the Power Train Oil System {3000, 3004, 5050, 5068} Guidelines for the Use of High Efficiency Filters for the Hydraulic Oil System and for the Power Train Oil System {3000, 3004, 5050, 5068}
3126B Petroleum Engine Auxiliary Temperature Sensor Circuit - Test
3126B Industrial Engines Air Inlet Heater Circuit - Test
2004/06/28 A Corrosion Testing Cable Group Helps Determine if Engine Parts Are Subject to Corrosion {0779, 0781, 0785}
3126B Industrial Engines Analog Sensor Open or Short Circuit - Test
3126B Industrial Engines Analog Sensor Supply Circuit - Test
3126B Petroleum Engine CAN Data Link Circuit - Test
3126B Petroleum Engine Coolant Level Sensor Circuit - Test
3126B Petroleum Engine Diagnostic Lamp Circuit - Test
3126B Petroleum Engine Digital Sensor Supply Circuit - Test