Torque For The Cab Platform Bolts May Be Incorrect
Usage:
TRACK-TYPE TRACTORSD11R (3KR1400-1642) TRACK-TYPE TRACTORS
Problem:
Four platform mounting bolts may have been tightened incorrectly during assembly on D10R (3KR1400-1642) Track-Type Tractors.
Solution:
Ensure that the bolt torque is correct.
Tighten two 7X-0392 (7/8-9) Bolts (1) to a torque of 750 NM (550 lb ft). Tighten two 8T-9312 (3/4-10) Bolts (2) to a torque of 475 NM (350 lb ft).
COPYRIGHT 2001 CATERPILLAR ALL RIGHTS RESERVED
Caterpillar Information System:
Inspect The Track Idler And Bogie Clearance Inspect The Track Idler And Bogie Clearance
988G Stall Speeds Require Careful Attention to Operating Parameters 988G Stall Speeds Require Careful Attention to Operating Parameters
D11R Implement Joysticks Are Sticking D11R Implement Joysticks Are Sticking
Hose Clamp, 8T-4983, Located Inside The Right Side Panel In The Cab, May Need To Be Tightened To An Increased Torque Hose Clamp, 8T-4983, Located Inside The Right Side Panel In The Cab, May Need To Be Tightened To An Increased Torque
Coils Assembled Incorrectly Coils Assembled Incorrectly
New Software Corrects Calibration Failures New Software Corrects Calibration Failures
Replacement Of Nuts With Locknuts On The Hydraulic Oil Tank For The Motor Grader Replacement Of Nuts With Locknuts On The Hydraulic Oil Tank For The Motor Grader
Modulating Valve Connectors May Not Be Fully Seated Modulating Valve Connectors May Not Be Fully Seated
New Caterpillar Yellow Cylinder Seals Provide Longer Service Life New Caterpillar Yellow Cylinder Seals Provide Longer Service Life
DAMAGED OR LOST 184-9866 BUCKET DUMP STOP ASSEMBLIES REQUIRE REPLACEMENT AND RECALIBRATION OF THE TILT LINKAGE POSITION SENSOR. DAMAGED OR LOST 184-9866 BUCKET DUMP STOP ASSEMBLIES REQUIRE REPLACEMENT AND RECALIBRATION OF THE TILT LINKAGE POSITION SENSOR.
Position Adjustment To Eliminate Battery Cable Interferences Position Adjustment To Eliminate Battery Cable Interferences
Low Level Leakage Experienced With The New Caterpillar Yellow Rod Seals Low Level Leakage Experienced With The New Caterpillar Yellow Rod Seals
Axle Housing to Final Drive Spindle Bolted Jiont Axle Housing to Final Drive Spindle Bolted Jiont
Temporary Loss Of Hydraulic Blade Control Temporary Loss Of Hydraulic Blade Control
Servicing The 183-5116 Fan Clutch Servicing The 183-5116 Fan Clutch
Alternate Pin Puller Location Alternate Pin Puller Location
Input Drive Shaft Between Torque Converter and Transmission Input Drive Shaft Between Torque Converter and Transmission
A New Engine Flash File Is Avaliable A New Engine Flash File Is Avaliable
Short In The Cigarette Lighter Can Cause A Fault Code Short In The Cigarette Lighter Can Cause A Fault Code
Tube Assembly May Loosen And Aerate The Hydraulic Oil Tube Assembly May Loosen And Aerate The Hydraulic Oil
Upgrade To M# 170-5664 Unit Test ; Fill Machine Upgrade To M# 170-5664 Unit Test & Fill Machine
Inspect Transmission Bolts Inspect Transmission Bolts
Elevator Downstops May Be Damaged Elevator Downstops May Be Damaged
Transmission Wiring Harness Transmission Wiring Harness