Turbocharger - Install
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 138-7575     | 连杆支架     | 2     |
B     | 4C-5599     | 防粘结剂     | -     |
- 将工具 (A) 和适当的起吊设备连接到涡轮增压器 (9) 和进气弯头上。
Show/hide table
图 1 | g01063422 |
- 在发动机上安装涡轮增压器 (9) 。 涡轮增压器的重量约为 100 kg (220 lb)。
- 将工具 (B) 涂抹在螺栓 (8) 上。 安装螺栓 (8) ,并拧紧至扭矩为 20 ± 2 N·m (15 ± 1 lb ft)。
- 将工具 (B) 涂抹在螺栓 (6) 上。 安装螺栓 (6) ,并拧紧至扭矩为 50 ± 10 N·m (37 ± 7 lb ft)。
- 从涡轮增压器 (9) 和进气弯头上拆下工具 (A) 和适当的起吊设备。
- 将工具 (B) 涂抹在螺栓 (5) 上。 安装螺栓 (5) ,并拧紧至扭矩为 50 ± 10 N·m (37 ± 7 lb ft)。
Show/hide table
图 2 | g01063415 |
- 连接管组件 (2) 和 (3) 。
- 连接管组件 (1) 和 (4) 。
注: 连接管组件 (1) 之前,在管组件 (1) 中倾倒一些清洁的发动机机油。 这在启动期间有助于润滑涡轮增压器的轴承。
- 加注冷却液系统。 请参阅操作和保养手册, "加注容量和建议"。
Caterpillar Information System:
3406E and 3456 Generator Set Engines Sensors and Electrical Connectors
G3520C and G3520E Generator Set Engines Turbocharger - Remove
3406E, C-10 and C-12 On-highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
C7 Marine Engine Electric Starting System - Test
C7 Engines for Caterpillar Built Machines Water Temperature Regulator - Test
C7 Marine Engine Cooling System - Inspect
C11 and C13 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C27 and C32 Industrial Engines Monitoring System - If Equipped
3512B and 3516B High Displacement Locomotive Engines Refill Capacities and Recommendations
2004/04/01 Revised Special Instruction, REHS2115, "Requirements for Installation of the 197-6700 Piston " is Available {1214, 1216}
3512B and 3516B High Displacement Locomotive Engines After Stopping Engine
3408E and 3412E Engines for Caterpillar Built Machines Atmospheric Pressure Sensor
3406E and 3456 Generator Set Engines Engine Cranks but Will Not Start
G3520C and G3520E Generator Set Engines Turbocharger - Disassemble - Dual Turbochargers
3406E, C-10 and C-12 On-highway Engines Accelerator Pedal (Throttle) Position Sensor Circuit - Test
G3520C and G3520E Generator Set Engines Turbocharger - Assemble - Dual Turbochargers
3406E and 3456 Generator Set Engines Coolant in Engine Oil
C-15 Petroleum Engine Auxiliary Water Pump
3406E and 3456 Generator Set Engines ECM Will Not Communicate with Other Systems or Display Modules
C7 Marine Engine Cooling System - Check - Overheating
3406E, C12, C15 and C18 Marine Engines Flash Codes
2004/04/01 The Heat Exchanger Bonnet can be Rotated on Certain Applications {1379}
3126B Petroleum Engine Installation Environment
G3520C and G3520E Generator Set Engines Exhaust Elbow - Remove and Install