After Stopping Engine
- 检查发动机曲轴箱油位。 将油位保持在油尺"发动机停机(ENGINE STOPPED)"一侧的"添加(ADD)"和"满(FULL)"标记之间。 应完全按照专门出版物, SEBU6251, "卡特彼勒商用柴油发动机用液建议"中所列出的所有润滑推荐来选择润滑油。
- 如有必要,进行小的调整。 修理渗漏处并拧紧松动的螺栓。
- 记下工时表的读数。 按本操作和保养手册, "保养周期表"(保养部分)中所述进行保养。
- 让发动机冷却下来。 检查冷却液液位。
- 如果预计会出现结冻温度,要检查冷却液是否具有防冻防护。 必须保护冷却系统,以防其在预计的最低外部温度下结冻。 请参阅专门出版物, SEBU6251, "卡特彼勒商用柴油发动机用液建议"。 如果必要,添加合适的冷却液/水混合液。
- 对所有被传动的设备进行必需的定期保养。 请参阅被驱动的原设备制造厂(OEM)提供的的说明书。
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Atmospheric Pressure Sensor
C-10 Petroleum Engine Fuel System Secondary Filter - Replace
3114, 3116, 3126 Engines Rear Seal Carrier
Requirements for Installation of the 197-6700 Piston {1214, 1216} Requirements for Installation of the 197-6700 Piston {1214, 1216}
C7 Marine Engine Aftercooler
Product Link PL-102C{7602} Product Link PL-102C{7602}
C7 Marine Engine Crankcase Breather
3500B Locomotive Engines Engine Mounts - Check
3406E and 3456 Generator Set Engines Engine Will Not Crank
C7 Marine Engine Turbocharger - Inspect
3406E and 3456 Generator Set Engines System Configuration Parameters
C-10 Petroleum Engine Engine Oil Level - Check
2004/04/01 Revised Special Instruction, REHS2115, "Requirements for Installation of the 197-6700 Piston " is Available {1214, 1216}
3512B and 3516B High Displacement Locomotive Engines Refill Capacities and Recommendations
C27 and C32 Industrial Engines Monitoring System - If Equipped
C11 and C13 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C7 Marine Engine Cooling System - Inspect
C7 Engines for Caterpillar Built Machines Water Temperature Regulator - Test
C7 Marine Engine Electric Starting System - Test
3406E, C-10 and C-12 On-highway Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
G3520C and G3520E Generator Set Engines Turbocharger - Remove
3406E and 3456 Generator Set Engines Sensors and Electrical Connectors
G3520C and G3520E Generator Set Engines Turbocharger - Install
3406E and 3456 Generator Set Engines Engine Cranks but Will Not Start