MID 036 - CID 1719 - FMI 12 Generator Output Power Sensor malfunction
Conditions Which Generate This Code:
This diagnostic code is applicable to generators that are equipped with the Electronic Modular Control Panel II+ (EMCP II+) only.
The Electronic Control Module (ECM) has determined that the load signal from the EMCP II+ may be invalid.
System Response:
The diagnostic code is logged and the engine is shut down.
Troubleshooting:
Test Step 1. Perform the following diagnostic procedure: "Generator Output Power Sensor"
Results:
- OK - STOP
Caterpillar Information System:
C12 Marine Engines Engine Oil Level Gauge - Calibrate
3126B Marine Engines Injection Actuation Pressure Sensor - Test
C13, C15, and C18 Generator Set Engines System Configuration Parameters
3126B Petroleum Engine Belt Tensioner - Inspect
C11 and C13 Petroleum Engines Fan Drive Bearing - Replace
G3516B Engines MID 036 - CID 0145 - FMI 04 12 Volt DC Power Supply short to ground
G3516B Engines MID 036 - CID 0145 - FMI 03 12 Volt DC Power Supply short to +batt
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Water Pump - Install
3412E and C30 Marine Engines Basic Engine
2004/03/01 New High Efficiency Oil Filters are Now Available {1308}
2004/03/01 New High Efficiency Oil Filters are Now Available {1308}
2004/03/22 New High Efficiency Oil Filters are Now Available {1308}
EMCP3 Voltage and Frequency Adjustment
G3408 and G3412 Engines Engine Oil and Filter - Change
D7G Series 2 and D7G Series II Track-Type Tractors Horn - Test
2004/04/01 Replacement of the Injection Actuation Pressure Control Valve {5051}
C-15 Petroleum Engine Cooling System
2004/05/01 Improved Water Temperature Regulator {1355}
G3516C and G3516E Gas Engines Engine Design
C13, C15, and C18 Generator Set Engines CID 0175 FMI 03 Engine Oil Temperature open/short to +batt
C13, C15, and C18 Generator Set Engines CID 0175 FMI 04 Engine Oil Temperature short to ground
C13, C15, and C18 Generator Set Engines Diagnostic Codes
2009/08/24 Calibration for the Engine Oil Level Gauge {1326}
2004/02/01 Updated ECM Software is Now Available for the Input Switch on the Air Conditioner Controls {7620}