CID 0175 FMI 04 Engine Oil Temperature short to ground
产生此代码的情况:
电子控制模块(ECM)可检测以下所有状况:
- ECM 读取到信号电压低于 0.2 VDC 持续八秒钟。
- ECM 至少已通电两秒钟。
系统响应:
ECM 将会记录此诊断代码。 诊断代码可在显示模块或 Caterpillar 电子技师(ET)上查看。 ECM 将发动机机油温度标为无效数据。 ECM 将发动机机油温度设定为与冷却液温度相同的数值。 如果冷却液温度传感器已经失效,则使用以下数值之一:
- 如果发动机正在运转,发动机机油温度将会被设定为 65 °C (149 °F)。
- 如果发动机不在运转,发动机机油温度将会被设定为−10 °C (14 °F)。
- 无
测试步骤 1. 进行以下的诊断步骤: 发动机温度传感器开路或短路 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
C13, C15, and C18 Generator Set Engines CID 0175 FMI 03 Engine Oil Temperature open/short to +batt
G3516C and G3516E Gas Engines Engine Design
2004/05/01 Improved Water Temperature Regulator {1355}
C-15 Petroleum Engine Cooling System
2004/04/01 Replacement of the Injection Actuation Pressure Control Valve {5051}
D7G Series 2 and D7G Series II Track-Type Tractors Horn - Test
G3408 and G3412 Engines Engine Oil and Filter - Change
EMCP3 Voltage and Frequency Adjustment
G3516B Engines MID 036 - CID 1719 - FMI 12 Generator Output Power Sensor malfunction
C12 Marine Engines Engine Oil Level Gauge - Calibrate
3126B Marine Engines Injection Actuation Pressure Sensor - Test
C13, C15, and C18 Generator Set Engines System Configuration Parameters
C13, C15, and C18 Generator Set Engines Diagnostic Codes
2009/08/24 Calibration for the Engine Oil Level Gauge {1326}
2004/02/01 Updated ECM Software is Now Available for the Input Switch on the Air Conditioner Controls {7620}
C7 Marine Engine Cooling System - Test
Reuse and Salvage Guideline for Front Suspension Cylinder Housings and Heads on Off-Highway Trucks {0374, 0599, 7201} Reuse and Salvage Guideline for Front Suspension Cylinder Housings and Heads on Off-Highway Trucks {0374, 0599, 7201}
2004/04/01 The Procedure for the Installation of the Electronic Unit Injector Has Changed {1290}
3412E Petroleum Engine Electrical System
G3520E Generator Set Engines Camshaft
C7 Marine Engine Inlet Manifold Pressure - Test
C13, C15, and C18 Generator Set Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
3508B, 3512B, and 3516B High Displacement Generator Sets Safety Messages
2005/06/20 A Parts Kit for the Piston Cooling Jets and Retainers for the Piston Cooling Jets is Now Cancelled {1331}