Belt Tensioner - Inspect
Show/hide table
Use of standard belts on this engine may cause an explosion which may result in personal injury or death. Only non-static belts should be used on this engine. |
Show/hide table
Illustration 1 | g00426964 |
Belt tensioner |
- Refer to the Disassembly and Assembly Manual for belt removal.
- Remove the belt.
- Inspect the belt tensioner for unusual noise, excessive looseness and/or shaking of the bearings.
- Inspect the other pulleys and idlers for unusual noise, excessive looseness and/or shaking of the bearings.
If the belt tensioner should require disassembly, refer to the Service Manual for the procedure.
Caterpillar Information System:
C11 and C13 Petroleum Engines Fan Drive Bearing - Replace
G3516B Engines MID 036 - CID 0145 - FMI 04 12 Volt DC Power Supply short to ground
G3516B Engines MID 036 - CID 0145 - FMI 03 12 Volt DC Power Supply short to +batt
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Water Pump - Install
3412E and C30 Marine Engines Basic Engine
2004/03/01 New High Efficiency Oil Filters are Now Available {1308}
2004/03/01 New High Efficiency Oil Filters are Now Available {1308}
2004/03/22 New High Efficiency Oil Filters are Now Available {1308}
3500B and 3500C Marine Engines Engine Harness - Rigid Wiring Harness
C13, C15, and C18 Generator Set Engines General Information
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Water Pump - Remove
G3516B Engines Diagnostic Codes
C13, C15, and C18 Generator Set Engines System Configuration Parameters
3126B Marine Engines Injection Actuation Pressure Sensor - Test
C12 Marine Engines Engine Oil Level Gauge - Calibrate
G3516B Engines MID 036 - CID 1719 - FMI 12 Generator Output Power Sensor malfunction
EMCP3 Voltage and Frequency Adjustment
G3408 and G3412 Engines Engine Oil and Filter - Change
D7G Series 2 and D7G Series II Track-Type Tractors Horn - Test
2004/04/01 Replacement of the Injection Actuation Pressure Control Valve {5051}
C-15 Petroleum Engine Cooling System
2004/05/01 Improved Water Temperature Regulator {1355}
G3516C and G3516E Gas Engines Engine Design
C13, C15, and C18 Generator Set Engines CID 0175 FMI 03 Engine Oil Temperature open/short to +batt