Usage:
START BY:
a. remove flywheel housing
b. remove timing gears and plate
1. Use tooling (A), and remove the rear camshaft bearing first.
2. Remove the remainder of the camshaft bearings with tooling (A).
Install Camshaft Bearings
| NOTICE |
|---|
Install camshaft bearings with the oil hole in the bearing in alignment with the oil hole in the block and the junction of the bearing above a horizontal center line through the bore of the bearing. |
1. Install the camshaft bearings in the cylinder block with tools (A) and (B) as follows:
a. Install the center bearing to a depth of 287.5 ± 0.8 mm (11.32 ± .03 in.) from the front surface of the block.
b. Install the rear bearing to a depth of 556.8 ± 0.8 mm (21.92 ± .03 in.) from the front of the block.
c. Install the front bearing even (flush) with the surface of the block and no more than 0.50 mm (.020 in.) deep. The oil hole in the bearing and cylinder block must be in alignment when installed.
END BY:
a. install timing gears and plate
b. install flywheel housing