MID 036 - CID 0091 - FMI 13 Throttle Position calibration required
产生此代码的情况:
电子控制模块(ECM)可检测以下状况:
- 油门位置传感器信号的占空比低于5%或高于95%。
该诊断代码表示油门限位设定不当。
系统响应:
Show/hide table
图 1 | g00764010 |
该诊断代码激活时,ECM 将理想发动机转速设定到编程设定的低怠速。 该诊断代码激活时,Caterpillar 电子技师(ET)将指示 0% 的油门位置。
该诊断代码激活时,理想发动机转速将返回低怠速。
测试步骤 1. 进行以下的诊断步骤: 油门位置传感器 - 标定
结果:
- 正常 - 停止
Caterpillar Information System:
3406C Generator Sets Model View Illustrations
Installation of Double Lip Wiper Seal{7562} Installation of Double Lip Wiper Seal{7562}
3406C Generator Sets Safety Messages
2003/10/06 Installation of the Correct Dust Seal in the Swing Gear and Bearing {7063}
G3304 and G3306 Engines Magneto - Assemble
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Line - Remove and Install
G3520C and G3520E Generator Set Engines Cylinder Head - Install
G3520C and G3520E Generator Set Engines Cylinder Head - Remove
Procedure for Tagging Rental Fleet {1000, 6000, 6700, 7000} Procedure for Tagging Rental Fleet {1000, 6000, 6700, 7000}
3500B and 3500C Marine Propulsion Engines Diagnostic Codes
G3500B Engines Electrohydraulic System Components
3618 Engine Starting Motor - Inspect
Recommendations for Caterpillar Gas Engine Cooling Systems{1350} Recommendations for Caterpillar Gas Engine Cooling Systems{1350}
3500B and 3500C Marine Propulsion Engines MID 036 - CID 0277 - FMI 08 Timing Calibration signal abnormal
3054C Industrial Engine Idler Gear - Remove and Install - Bosch EPVE Fuel Injection Pump
G3520C and G3520E Generator Set Engines Thermostatic Valve - Disassemble
G3520C and G3520E Generator Set Engines Thermostatic Valve - Assemble
Caterpillar has released a new Cylinder Head, a new Cylinder Block, a new Cylinder Head Gasket, and a new Bracket for the Camshaft Follower on the C-10 and C-12 Truck Engines{1101, 1124, 1201, 1209} Caterpillar has released a new Cylinder Head, a new Cylinder Block, a new Cylinder Head Gasket, and a new Bracket for the Camshaft Follower on the C-10 and C-12 Truck Engines{1101, 1124, 1201, 1209}
G3520C and G3520E Generator Set Engines Crankcase Breather - Remove and Install
G3520C and G3520E Generator Set Engines Thermostatic Valve - Remove
G3520C and G3520E Generator Set Engines Thermostatic Valve - Install
G3304 and G3306 Engines Magneto Drive - Remove and Install
G3520C and G3520E Generator Set Engines Exhaust Manifold - Remove
G3520C and G3520E Generator Set Engines Exhaust Manifold - Install