Engine Oil Line - Remove and Install
Removal Procedure
- Loosen nut (6) that attaches oil line (1) to the cylinder block.
Show/hide table
Illustration 1 | g00997100 |
- Remove banjo bolt (3) and remove washers (2) from the cylinder block.
- Remove oil pressure switch (4) and remove adapter (5) from the cylinder head. Remove washers (not shown).
- Remove oil line (1) from the engine.
Installation Procedure
- Position oil line (1) on the engine.
Show/hide table
Illustration 2 | g00997100 |
- Position oil pressure switch (4), adapter (5), and washers on oil line (1). Install the oil line to the cylinder block.
- Position banjo bolt (3) and washers (2) to oil line (1). Install the oil line to the cylinder head.
- Tighten nut (6) that attaches oil line (1) to the cylinder block.
- Tighten oil pressure switch (4) to 10 N·m (90 lb in).
- Tighten banjo bolt (3) to 12 N·m (105 lb in).
Caterpillar Information System:
G3520C and G3520E Generator Set Engines Cylinder Head - Install
G3520C and G3520E Generator Set Engines Cylinder Head - Remove
Procedure for Tagging Rental Fleet {1000, 6000, 6700, 7000} Procedure for Tagging Rental Fleet {1000, 6000, 6700, 7000}
3500B and 3500C Marine Propulsion Engines Diagnostic Codes
G3500B Engines Electrohydraulic System Components
3618 Engine Starting Motor - Inspect
Product Link 151/201 Commands
G3500 Engines Air Starting System - Starting with an Air Prelube Pump
Product Link 151/201 Spare Input Configure
Product Link 151/201 Wireless Service Configure
Product Link 151/201 Report Parameters Configure
Product Link 151/201 Installation Parameters Configure
G3304 and G3306 Engines Magneto - Assemble
2003/10/06 Installation of the Correct Dust Seal in the Swing Gear and Bearing {7063}
3406C Generator Sets Safety Messages
Installation of Double Lip Wiper Seal{7562} Installation of Double Lip Wiper Seal{7562}
3406C Generator Sets Model View Illustrations
3500B and 3500C Marine Propulsion Engines MID 036 - CID 0091 - FMI 13 Throttle Position calibration required
Recommendations for Caterpillar Gas Engine Cooling Systems{1350} Recommendations for Caterpillar Gas Engine Cooling Systems{1350}
3500B and 3500C Marine Propulsion Engines MID 036 - CID 0277 - FMI 08 Timing Calibration signal abnormal
3054C Industrial Engine Idler Gear - Remove and Install - Bosch EPVE Fuel Injection Pump
G3520C and G3520E Generator Set Engines Thermostatic Valve - Disassemble
G3520C and G3520E Generator Set Engines Thermostatic Valve - Assemble
Caterpillar has released a new Cylinder Head, a new Cylinder Block, a new Cylinder Head Gasket, and a new Bracket for the Camshaft Follower on the C-10 and C-12 Truck Engines{1101, 1124, 1201, 1209} Caterpillar has released a new Cylinder Head, a new Cylinder Block, a new Cylinder Head Gasket, and a new Bracket for the Camshaft Follower on the C-10 and C-12 Truck Engines{1101, 1124, 1201, 1209}