Fuel Filter Base - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect hose assembly (1) and hose assembly (5) from base assembly (2) .
Show/hide table
Illustration 1 | g00994496 |
- Plug and cap all openings. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
- Remove bolts (4) , washers (3) , and the nuts. Remove base assembly (2) .
Caterpillar Information System:
G3304 and G3306 Engines Auxiliary Water Pump - Remove
C1.5 and C2.2 Generator Set Engines Crankshaft Main Bearings - Install
C1.5 and C2.2 Generator Set Engines Glow Plugs - Remove and Install
3046 Engine for Caterpillar Built Machines Fuel System - Prime - Distributor Pump
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Pressure Switch - Remove and Install
3044C Industrial Engine and Engines for Caterpillar Built Machines Fuel Injection Nozzle - Test
C1.5 and C2.2 Marine Generator Set Engines Coolant Temperature Switch - Remove and Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Coolant Recommendations
C1.5 and C2.2 Generator Set Engines Crankshaft - Install
C1.5 and C2.2 Generator Set Engines Crankshaft Main Bearings - Remove
C1.5 and C2.2 Marine Generator Set Engines Pistons and Connecting Rods - Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Cold Weather Lubricants
G3520C and G3520E Generator Set Engines Fuel Control Valve - Remove and Install
3500B and 3500C Marine Propulsion Engines Customer Parameters Worksheet
C1.5 and C2.2 Generator Set Engines Fuel Filter Base - Disassemble
3046 Engine for Caterpillar Built Machines Fuel Injection Timing - Check - Distributor Pump
XQ125 Generator Set Battery Electrolyte Level - Check
3054E and 3056E Industrial Engines Alternator and Fan Belts - Inspect/Adjust/Replace
G3304 and G3306 Engines Auxiliary Water Pump - Install
C1.5 and C2.2 Generator Set Engines Fuel Filter Base - Assemble
C15 and C18 Petroleum Generator Sets Walk-Around Inspection
3500 Marine Engines Accumulator
C1.5 and C2.2 Generator Set Engines Fuel Filter Base - Install
3500 Marine Engines Accumulator