Glow Plugs - Remove and Install
Removal Procedure
Start By:
- Remove the fuel injection lines, if necessary. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
- Remove nuts (1) and washers (2) from bus bar (3) on glow plugs (4) .
Show/hide table
Disconnect batteries before performance of any service work. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g00820321 |
- Remove bus bar (3) from glow plugs (4) .
- Remove glow plugs (4) from the cylinder head.
Installation Procedure
- Install glow plugs (4) in the cylinder head. Tighten the glow plugs to a torque of 18 N·m (13 lb ft).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 2 | g00820321 |
- Install bus bar (3) on glow plugs (4) .
- Install washers (2) and nuts (1) on glow plugs (4). Tighten nuts (1) to a torque of 1.2 N·m (11 lb in).
End By: Install the fuel injection lines, if necessary. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
Caterpillar Information System:
3046 Engine for Caterpillar Built Machines Fuel System - Prime - Distributor Pump
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Pressure Switch - Remove and Install
3044C Industrial Engine and Engines for Caterpillar Built Machines Fuel Injection Nozzle - Test
C1.5 and C2.2 Marine Generator Set Engines Coolant Temperature Switch - Remove and Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Coolant Recommendations
C1.5 and C2.2 Generator Set Engines Crankshaft - Install
C1.5 and C2.2 Generator Set Engines Crankshaft Main Bearings - Remove
C1.5 and C2.2 Marine Generator Set Engines Pistons and Connecting Rods - Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Cold Weather Lubricants
C1.5 and C2.2 Generator Set Engines Engine Oil Pan - Remove and Install
C15 and C18 Petroleum Generator Sets Generator Operation
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install
C1.5 and C2.2 Generator Set Engines Crankshaft Main Bearings - Install
G3304 and G3306 Engines Auxiliary Water Pump - Remove
C1.5 and C2.2 Generator Set Engines Fuel Filter Base - Remove
G3520C and G3520E Generator Set Engines Fuel Control Valve - Remove and Install
3500B and 3500C Marine Propulsion Engines Customer Parameters Worksheet
C1.5 and C2.2 Generator Set Engines Fuel Filter Base - Disassemble
3046 Engine for Caterpillar Built Machines Fuel Injection Timing - Check - Distributor Pump
XQ125 Generator Set Battery Electrolyte Level - Check
3054E and 3056E Industrial Engines Alternator and Fan Belts - Inspect/Adjust/Replace
G3304 and G3306 Engines Auxiliary Water Pump - Install
C1.5 and C2.2 Generator Set Engines Fuel Filter Base - Assemble
C15 and C18 Petroleum Generator Sets Walk-Around Inspection