Crankshaft Main Bearings - Remove
Removal Procedure
Start By:
- Remove the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Crankshaft Main Bearings
- Remove bolts (1) that secure the upper half of main bearing cap (2) to the lower half of main bearing cap (7) .
Show/hide table
Illustration 1 | g00830378 |
Note: Mark the halves of the main bearing carriers for later installation.
- Separate the upper half of main bearing cap (2) from the lower half of main bearing cap (7) .
Note: Dowels (5) are installed in each bearing cap in order to align the two halves of the main bearing carrier.
- Remove thrust washers (3) and thrust washer (6) .
- Remove main bearings (4) from the main bearing caps.
Crankshaft Bearing (Front)
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-0510     | Driver Gp     | 1     |
- Remove crankshaft bearing (8). Use Tooling (A) and a hammer to drive out crankshaft bearing (8) from the inside of cylinder block (9) .
Show/hide table
Illustration 2 | g01038412 |
Caterpillar Information System:
C1.5 and C2.2 Marine Generator Set Engines Pistons and Connecting Rods - Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Cold Weather Lubricants
C1.5 and C2.2 Generator Set Engines Engine Oil Pan - Remove and Install
C15 and C18 Petroleum Generator Sets Generator Operation
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Remove
3412C Generator Sets Starting the Engine - EMCP II and EMCP II+ (If Equipped)
3456 Generator Sets Overspeed
3456 Generator Sets Engine Shutoffs and Engine Alarms
C1.5 and C2.2 Marine Generator Set Engines Rocker Shaft and Pushrod - Install
C1.5 and C2.2 Marine Generator Set Engines Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
C1.5 and C2.2 Generator Set Engines Crankshaft - Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Coolant Recommendations
C1.5 and C2.2 Marine Generator Set Engines Coolant Temperature Switch - Remove and Install
3044C Industrial Engine and Engines for Caterpillar Built Machines Fuel Injection Nozzle - Test
C1.5 and C2.2 Marine Generator Set Engines Engine Oil Pressure Switch - Remove and Install
3046 Engine for Caterpillar Built Machines Fuel System - Prime - Distributor Pump
C1.5 and C2.2 Generator Set Engines Glow Plugs - Remove and Install
C1.5 and C2.2 Generator Set Engines Crankshaft Main Bearings - Install
G3304 and G3306 Engines Auxiliary Water Pump - Remove
C1.5 and C2.2 Generator Set Engines Fuel Filter Base - Remove
G3520C and G3520E Generator Set Engines Fuel Control Valve - Remove and Install
3500B and 3500C Marine Propulsion Engines Customer Parameters Worksheet