Engine Valve Lash - Adjust
注: 有关气门间隙调整和气门过梁调整的步骤,请参阅测试和调整, "气门间隙和气门摇臂的调整"。 请咨询您的卡特彼勒代理商以便获得帮助。
气门摇臂
调整气门摇臂。 对每个气缸的两个气门摇臂都执行该程序。 调整每一个气缸的气门摇臂之后,如有必要,继续进行气门间隙调整。
发动机气门间隙
Show/hide table
注意 |
---|
只有有资格的维修人员才能进行该项保养工作。对于整个气门间隙调整步骤,请参考维修手册或与卡特彼勒代理商联系。 气门间隙调整不适当的卡特彼勒发动机工作效率会降低。 这样会使燃料消耗量增加和/或缩短发动机部件寿命。 |
进行气门间隙调整前,必须先调整气门摇臂。 如果气门间隙在公差范围内,则不必调整气门间隙。
在发动机处于冷态时,调整气门间隙。 在发动机停机并拆下气门室盖后,发动机可认为处于冷态下。 进行保养前要防止杂质进入气缸盖上部和配气机构。 彻底清洁气门室盖周围的区域。
有关气门间隙的设定值,请参阅操作和保养手册, "产品说明"专题(产品资料部分)。
Caterpillar Information System:
3044C Industrial Engine Overhaul Considerations
3406E and 3456 Generator Set Engines Speed/Timing Sensor
C15 and C18 Petroleum Generator Sets Generator Load - Check
3054C Industrial Engine Fuel Injection Pump - Install - Delphi DP210
3054C Industrial Engine Fuel Injection Pump - Remove - Delphi DP210
C9 Marine Engines Air Inlet Heater Circuit - Test
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Accelerator Pedal (Throttle) Position Sensor Circuit - Test
3056E Industrial Engine Connecting Rod Bearing Journal
3056E Industrial Engine Electrical System
C9 Marine Engines Injection Actuation Pressure Sensor - Test
3500B Engines Air Shutoff
C9 Marine Engines and C9 Marine Generator Sets Exhaust Manifold - Remove and Install
C15 On-Highway Engine Flywheel
C9 Marine Engines and C9 Marine Generator Sets Water Temperature Regulator - Remove and Install
3500B and 3500 Marine Propulsion Engines with EUI Option Fuel Injector - Adjust
C15 On-highway Engine Piston Cooling Jet
Installation Instructions for the 9W-1494 Service Meter Kit {7478} Installation Instructions for the 9W-1494 Service Meter Kit {7478}
C9 Marine Engines and C9 Marine Generator Sets Fuel Priming Pump - Remove and Install
C18 Marine and Marine Generator Set Engines Engine Oil Pan
3054E Industrial Engine Engine Oil Pan - Remove and Install
3054E Industrial Engine Engine Oil Pump - Install - Engines Without a Balancer
3054E Industrial Engine Engine Oil Pump - Remove - Engines Without a Balancer
C9 Marine Engines and C9 Marine Generator Sets Fuel Filter Base - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Heat Exchanger - Remove