Fuel Injector - Adjust
注: 检查完发动机气门间隙之后,再进行本步骤。
Show/hide table
电子控制模块产生高电压。 为防止人身伤害,确保电子控制模块没被通电,单体喷油器被断开。 |
Show/hide table
注意 |
---|
在对燃油喷油器进行间隙调整之前,凸轮轴相对于曲轴的正时必须调整正确。 旋转曲轴之前,正时销必须从凸轮轴上取下来,否则将会对缸体造成损坏。 |
按照系统操作/测试和调整, "燃油系统"专题,检查燃油喷油器间隙的调整。 如有必要,调整燃油喷油器的间隙。
Caterpillar Information System:
C9 Marine Engines and C9 Marine Generator Sets Water Temperature Regulator - Remove and Install
C15 On-Highway Engine Flywheel
3500B and 3500 Marine Propulsion Engines with EUI Option Engine Valve Lash - Adjust
3044C Industrial Engine Overhaul Considerations
3406E and 3456 Generator Set Engines Speed/Timing Sensor
C15 and C18 Petroleum Generator Sets Generator Load - Check
3054C Industrial Engine Fuel Injection Pump - Install - Delphi DP210
3054C Industrial Engine Fuel Injection Pump - Remove - Delphi DP210
C9 Marine Engines Air Inlet Heater Circuit - Test
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Accelerator Pedal (Throttle) Position Sensor Circuit - Test
3056E Industrial Engine Connecting Rod Bearing Journal
3056E Industrial Engine Electrical System
C15 On-highway Engine Piston Cooling Jet
Installation Instructions for the 9W-1494 Service Meter Kit {7478} Installation Instructions for the 9W-1494 Service Meter Kit {7478}
C9 Marine Engines and C9 Marine Generator Sets Fuel Priming Pump - Remove and Install
C18 Marine and Marine Generator Set Engines Engine Oil Pan
3054E Industrial Engine Engine Oil Pan - Remove and Install
3054E Industrial Engine Engine Oil Pump - Install - Engines Without a Balancer
3054E Industrial Engine Engine Oil Pump - Remove - Engines Without a Balancer
C9 Marine Engines and C9 Marine Generator Sets Fuel Filter Base - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Heat Exchanger - Remove
2003/08/01 An Improved Flywheel Is Used {1156}
C15 On-highway Engine Boost Pressure Sensor
3054E Industrial Engine Engine Oil Relief Valve - Remove and Install - Engine without Balancer Group