Fuel Injection Nozzles - Install
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 用清洁的发动机机油润滑座垫圈 (6) 。 将座垫圈安装在缸盖中。
注: 如果重新使用原来的座垫圈,喷油嘴的凸出量将不正确。
Show/hide table
图 1 | g00975210 |
- 将 O 形密封圈 (5) 安装到喷油嘴 (1) 上。 将喷油嘴安装到缸盖中。
注: 定位销 (X) 必须在卡箍 (4) 对面。
- 将卡箍 (4) 定位到喷油嘴上。 安装螺栓 (3) 。 拧紧螺栓至扭矩为 27 N·m (20 lb ft)。
- 将软管 (2) 安装在喷油嘴上。
End By: 安装喷油管路。 请参阅 拆解和组装, "燃油喷油管路 - 拆卸和安装"。
Caterpillar Information System:
3044C Industrial Engine Battery - Replace
C11 and C13 Engines for Caterpillar Built Machines Fuel System Pressure - Test
3054C Industrial Engine Fuel Injection Nozzles - Remove
C15 and C18 Petroleum Generator Sets Fuel Conservation Practices
C1.5 and C2.2 Generator Sets Engine Operation
C11 and C13 Engines for Caterpillar Built Machines Inlet Manifold Pressure - Test
3054C Industrial Engine Fuel Injection Lines - Remove and Install
C9 Marine Engines Engine Pressure Sensor Open or Short Circuit - Test
3054E Industrial Engine Glow Plugs - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Turbocharger - Install
XQ60 Rental Generator Set Fire Prevention and Explosion Prevention
C9 Marine Engines Analog Sensor Supply Circuit - Test
C9 Marine Engines and C9 Marine Generator Sets Exhaust Manifold - Remove and Install
3500B Engines Air Shutoff
C9 Marine Engines Injection Actuation Pressure Sensor - Test
3056E Industrial Engine Electrical System
3056E Industrial Engine Connecting Rod Bearing Journal
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Accelerator Pedal (Throttle) Position Sensor Circuit - Test
C9 Marine Engines Air Inlet Heater Circuit - Test
3054C Industrial Engine Fuel Injection Pump - Remove - Delphi DP210
3054C Industrial Engine Fuel Injection Pump - Install - Delphi DP210
C15 and C18 Petroleum Generator Sets Generator Load - Check
3406E and 3456 Generator Set Engines Speed/Timing Sensor
3044C Industrial Engine Overhaul Considerations