Prechamber
Show/hide table
Illustration 1 | g00911845 |
(1) Bolt
- Diameter ... 3/8
- Seat the prechamber assembly into the bore of the cylinder head by alternate tightening of the bolts.
- Loosen the bolts once the prechamber assembly is seated in the bore of the cylinder head.
- Alternate the tightening of one bolt to the other bolt. Tighten the hold down bolts:
Torque ... 5 N·m (44 lb in)
- Tighten hold down bolts by the following degrees:
Degrees of rotation ... 60
- Tighten hold down bolts by the following additional degrees:
Degrees of rotation ... 60
- Tighten hold down bolts by the following additional degrees:
Degrees of rotation ... 60
Note: The total degrees of turn from the initial torque of 5 N·m (44 lb in) is 180 ± 5 degrees. Inadequate turning of the bolt may shorten the life of the bolt. Turning the bolt not far enough can lead to an inadequate load on the gasket. This may result in coolant leaks into the combustion chamber.
(2) Plug
- Torque ... 15 N·m (11 lb ft)
(3) O-rings
Lubricate the O-ring with 5N-5561 Silicone Lubricant prior to assembly.
(4) Check valve
- Torque ... 115 ± 15 N·m (85 ± 11 lb ft)
Caterpillar Information System:
PMG3516 Power Module Additional Messages
PMG3516 Power Module Safety Messages
3056E Industrial Engine Fuel Injection
C-15 On-Highway Engine Fuel System
3054E and 3056E Industrial Engines Fuel System - Prime
G3306 Engine Safety Messages
2002/08/12 A Summary of Revisions Will Start to Appear In Disassembly And Assembly Revisions {1000, 7000}
C-10 and C-12 On-Highway Engines Turbocharger - Install
C-10 and C-12 On-Highway Engines Turbocharger - Remove
C-15 On-Highway Engine Turbocharger - Install
C-15 On-Highway Engine Turbocharger - Remove
C-15 On-Highway Engine Modulating Valve - Remove and Install
G3612 and G3616 Engines Prechamber
3054E and 3056E Industrial Engines Starting the Engine
3512B Marine Auxiliary Engine Engine Monitoring System
Torque Specifications Plugs
G3500B Engines Safety Messages
C9 On-highway Engines Engine Crankcase Breather - Clean
C11 and C13 Engines for Caterpillar Built Machines Turbocharger - Inspect
2002/08/01 2002A Service Pack 1 for Caterpillar Electronic Technician (Cat ET) is now available {0785}
2002/08/19 2002A Service Pack 1 for Caterpillar Electronic Technician (Cat ET) is Now Available {0785}
3606, 3608, 3612, 3616 and 3618 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Panel View Monitor Troubleshooting Checks
C-15 On-Highway Engine Wastegate - Test
3054E and 3056E Industrial Engines Sensors and Electrical Components