Starting the Engine
Note: Do not adjust the engine speed control during start-up. The electronic control module (ECM) will control the engine speed during start-up.
- Disengage any driven equipment.
- Turn the keyswitch to the RUN position. Leave the keyswitch in the RUN position for 20 seconds.
- Turn the keyswitch to the START position in order to engage the starting motor and crank the engine.
Show/hide table
NOTICE Do not engage the starting motor when flywheel is turning. Do not start the engine under load.
If the engine fails to start within 30 seconds, release the starter switch or button and wait two minutes to allow the starting motor to cool before attempting to start the engine again.
- Allow the keyswitch to return to the RUN position after the engine starts.
- Repeat step 2 through step 4 if the engine fails to start.
- Disengage any driven equipment.
- Turn the keyswitch to the START position in order to engage the starting motor and crank the engine.
Show/hide table
NOTICE Do not engage the starting motor when flywheel is turning. Do not start the engine under load.
If the engine fails to start within 30 seconds, release the starter switch or button and wait two minutes to allow the starting motor to cool before attempting to start the engine again.
- Allow the keyswitch to return to the RUN position after the engine starts.
- Repeat step 2 and step 3 if the engine fails to start.
Caterpillar Information System:
G3612 and G3616 Engines Prechamber
G3612 and G3616 Engines Prechamber
PMG3516 Power Module Additional Messages
PMG3516 Power Module Safety Messages
3056E Industrial Engine Fuel Injection
C-15 On-Highway Engine Fuel System
3054E and 3056E Industrial Engines Fuel System - Prime
G3306 Engine Safety Messages
2002/08/12 A Summary of Revisions Will Start to Appear In Disassembly And Assembly Revisions {1000, 7000}
C-10 and C-12 On-Highway Engines Turbocharger - Install
C-10 and C-12 On-Highway Engines Turbocharger - Remove
C-15 On-Highway Engine Turbocharger - Install
3512B Marine Auxiliary Engine Engine Monitoring System
Torque Specifications Plugs
G3500B Engines Safety Messages
C9 On-highway Engines Engine Crankcase Breather - Clean
C11 and C13 Engines for Caterpillar Built Machines Turbocharger - Inspect
2002/08/01 2002A Service Pack 1 for Caterpillar Electronic Technician (Cat ET) is now available {0785}
2002/08/19 2002A Service Pack 1 for Caterpillar Electronic Technician (Cat ET) is Now Available {0785}
3606, 3608, 3612, 3616 and 3618 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Panel View Monitor Troubleshooting Checks
C-15 On-Highway Engine Wastegate - Test
3054E and 3056E Industrial Engines Sensors and Electrical Components
C9 Urban Transit Bus Engine Water Temperature Regulator
3126B and 3126E Truck Engines Water Pump