Fuel Filter Base
Show/hide table
Illustration 1 | g00888095 |
(1) Tighten the two bolts to the following torque. ...
(2) Sealing washers
(3) Tighten the banjo bolt to the following torque. ...
Apply 4C-4030 Thread Lock Compound to the M16 setscrews.
Tighten the bolts for the filter bracket (not shown) to the following torque:
- M10 ...
44 N·m (32 lb ft)
Filter bracket to the cylinder head
- M16 ...
44 N·m (32 lb ft)
Filter bracket to the engine block
Install new sealing washers when the banjo bolt is removed. Do not reuse the original sealing washers.
Caterpillar Information System:
3412E, C30 and C32 Marine Engines System Overview
G3500 Generator Sets Emergency Stopping
G3500 Generator Sets Plate Locations and Film Locations
Break-In Procedure for New Cylinder Liners and Piston Rings{1215, 1216} Break-In Procedure for New Cylinder Liners and Piston Rings{1215, 1216}
2002/06/01 Corrections to Disassembly and Assembly, RENR1333, "3618 Engine" , "Piston and Connecting Rods - Install" {1214}
C27 and C32 Generator Set Engines Engine Oil Filter Base - Assemble
797B Off-Highway Truck Air System Control Valve (Air Dryer)
G3500 Generator Sets Overhaul (Major)
2002/04/01 A New Connecting Rod Is Available {1218}
C27 and C32 Generator Set Engines Engine Oil Filter Base - Disassemble
G3600 Engines Inlet Air System - Inspect
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Install
C18 Generator Set Engine Rating Definitions
3500 Engines Mechanical Gauge - Test
3056E Industrial Engine Turbocharger
3412E, C30 and C32 Marine Engines Water Temperature Regulator - Remove and Install
3056E Industrial Engine Crankcase Breather
C18 Marine Engines Sensors and Electrical Components
Electronic Modular Control Panel II+ (EMCP II+) Sensors
3056E Industrial Engine Water Pump
Electronic Modular Control Panel II+ (EMCP II+) Voltmeter/Ammeter Programming OP8
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Water Pump
Electronic Modular Control Panel II+ (EMCP II+) Engine Setpoint Verification OP9
Electronic Modular Control Panel II+ (EMCP II+) Diagnostic Codes