3056E Industrial Engine Caterpillar


Crankcase Breather

Usage:

3056E 356


Illustration 1g00945263
The crankcase breather

(1) Tighten the bolts to the following torque. ... 9 N·m (80 lb in)

(2) Apply 9S-3263 Thread Lock Compound to the adapter. Tighten the adapter to the following torque. ... 30 N·m (22 lb ft)

Note: There is no specific torque for the compression nuts.

(3) Finger tighten both the compression nuts on the elbow. Rotate the compression nuts again by 1.25 turns.

Tighten the bolts (not shown) that fasten the bracket to the cylinder head to the following torque. ... 44 N·m (32 lb ft)

Caterpillar Information System:

3412E, C30 and C32 Marine Engines Water Temperature Regulator - Remove and Install
3056E Industrial Engine Turbocharger
3500 Engines Mechanical Gauge - Test
C18 Generator Set Engine Rating Definitions
3056E Industrial Engine Fuel Filter Base
3412E, C30 and C32 Marine Engines System Overview
G3500 Generator Sets Emergency Stopping
G3500 Generator Sets Plate Locations and Film Locations
Break-In Procedure for New Cylinder Liners and Piston Rings{1215, 1216} Break-In Procedure for New Cylinder Liners and Piston Rings{1215, 1216}
2002/06/01 Corrections to Disassembly and Assembly, RENR1333, "3618 Engine" , "Piston and Connecting Rods - Install" {1214}
C27 and C32 Generator Set Engines Engine Oil Filter Base - Assemble
797B Off-Highway Truck Air System Control Valve (Air Dryer)
C18 Marine Engines Sensors and Electrical Components
Electronic Modular Control Panel II+ (EMCP II+) Sensors
3056E Industrial Engine Water Pump
Electronic Modular Control Panel II+ (EMCP II+) Voltmeter/Ammeter Programming OP8
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Water Pump
Electronic Modular Control Panel II+ (EMCP II+) Engine Setpoint Verification OP9
Electronic Modular Control Panel II+ (EMCP II+) Diagnostic Codes
G3500 Generator Sets Voltage Regulators
C18 Marine Auxiliary Engine Model View Illustrations
Electronic Modular Control Panel II+ (EMCP II+) Relay Driver Module
Electronic Modular Control Panel II+ (EMCP II+) Synchronizing Lights Module
Electronic Modular Control Panel II+ (EMCP II+) System Communication Module (Customer)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.