Temperature Gauge
Show/hide table
| |
| Illustration 1 | g00870239 |
Show/hide table
| Calibration Chart | ||
| Pointer Position | Test Temperature | Direction of pointer travel |
| A(1) | |
Clockwise |
| B | |
Clockwise |
| C(2) | |
Clockwise |
Show/hide table
| (1) | The pointer must not move beyond the end of the indicator band. |
| (2) | The pointer must stop between 0 and |
Caterpillar Information System:
2002/03/01 A New Service Manual, RENR5971, "System Operation And Programming Guides For Digital Governor Control Used On 3618 Engine" Is Available {1908}
3500 Generator Set Engines Pressure Gauge - Hydraulic Oil
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3618 Engine Thermocouple - Test - Main Bearings' Thermocouples
3500 Industrial Engines Vacuum Gauge
3618 Engine Particle Detector - Test
3618 Engine Oil Mist Detector - Test
3618 Engine Oil Pressure Transducer - Test - Shutdown for Low Engine Oil pressure
3500 Generator Set Engines Pressure Gauge - Engine Oil
2002/03/11 Correction to Information Regarding the Need for Timing Calibration after Replacing the Engine ECM {1901, 1912, 1912}
3500 Industrial Engines Differential Pressure Gauge
3500 Generator Set Engines Pressure Gauge
G3612 and G3616 Engines Spark Plugs - Remove and Install
G3612 and G3616 Engines Detonation Sensor - Remove and Install
3500 Generator Set Engines Temperature Gauge
3618 Engine Transducer - Calibrate
3406E, C12, C15 and C18 Marine Engines Sensors and Electrical Connectors
3406E, C12, C15 and C18 Marine Engines Analog Sensor Supply Circuit - Test
3406E, C12, C15 and C18 Marine Engines Electrical Power Supply Circuit - Test
N3 Series Brushless Alternators Stator - Test
G3612 and G3616 Engines Fuel Lines - Remove and Install
3500 Generator Set Engines Sending Unit - Engine Oil Pressure
3500 Generator Set Engines Sending Unit - Water Temperature
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Electrical Connectors and Functions