Pressure Gauge - Engine Oil
Show/hide table
| |
| Illustration 1 | g00505699 |
Show/hide table
| |
| Illustration 2 | g00505747 |
Note: Warm the indicator for a minimum of five minutes with 27.2 ± 0.3 volts before testing the indicator.
(1) Test voltage ... 27.2 ± 0.3
(2) Resistance
(3) Negative case ground
Note: A mounting clamp or a mount clamp stud is not an adequate ground.
Show/hide table
| Calibration Chart | ||
| Pointer Position | Test Resistance | Direction of pointer travel |
| |
240 + 19 − 15 | Counterclockwise |
| |
172 ± 4 | Counterclockwise |
| |
34 ± 7 | Clockwise |
Caterpillar Information System:
2002/03/11 Correction to Information Regarding the Need for Timing Calibration after Replacing the Engine ECM {1901, 1912, 1912}
3500 Industrial Engines Differential Pressure Gauge
3500 Generator Set Engines Pressure Gauge
3054 and 3056 Industrial and Generator Set Engines Vibration Damper and Pulley
3618 Engine Engine Speed Switch - Test
N3 Series Brushless Alternators Rectifier - Test
G3612 and G3616 Engines Crankcase Pressure Sensor - Remove and Install
3618 Engine Oil Pressure Contactor - Test - Shutdown for Low Engine Oil Pressure
N3 Series Brushless Alternators Capacitor - Test
N3 Series Brushless Alternators Field Winding - Test
3500 Generator Set Engines Ammeter
3406E, C12, C15 and C18 Marine Engines System Configuration Parameters
3618 Engine Oil Pressure Transducer - Test - Shutdown for Low Engine Oil pressure
3618 Engine Oil Mist Detector - Test
3618 Engine Particle Detector - Test
3500 Industrial Engines Vacuum Gauge
3618 Engine Thermocouple - Test - Main Bearings' Thermocouples
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3500 Generator Set Engines Pressure Gauge - Hydraulic Oil
2002/03/01 A New Service Manual, RENR5971, "System Operation And Programming Guides For Digital Governor Control Used On 3618 Engine" Is Available {1908}
3500 Generator Set Engines Temperature Gauge
G3612 and G3616 Engines Spark Plugs - Remove and Install
G3612 and G3616 Engines Detonation Sensor - Remove and Install
3500 Generator Set Engines Temperature Gauge