Engine Speed Switch - Test
To ensure that the engine speed switch is operating properly, perform this test during engine operation.
- Adjust the engine speed to 850 rpm.
- Press "75% VERIFY" button (1) on the engine speed switch and hold the button down.
Show/hide table
Illustration 1 | g00867794 |
Engine speed switch (1) "75% VERIFY" button (2) "RESET" button (3) "OVERSPEED" indicator |
- Monitor the engine rpm and slowly increase the engine speed.
If the engine speed switch is properly adjusted, the engine will shut down at a speed of 890 ± 10 rpm. Red "OVERSPEED" indicator (3) will illuminate.
If the shutdown does not occur at a speed of 890 ± 10 rpm, adjust the engine speed switch according to Testing and Adjusting, "Engine Speed Switch - Calibrate".
Note: The engine speed switch must be reset before the engine can be restarted. Press "RESET" button (2) .
Caterpillar Information System:
N3 Series Brushless Alternators Rectifier - Test
G3612 and G3616 Engines Crankcase Pressure Sensor - Remove and Install
3618 Engine Oil Pressure Contactor - Test - Shutdown for Low Engine Oil Pressure
N3 Series Brushless Alternators Capacitor - Test
N3 Series Brushless Alternators Field Winding - Test
3500 Generator Set Engines Ammeter
3406E, C12, C15 and C18 Marine Engines System Configuration Parameters
3054 and 3056 Industrial and Generator Set Engines Connecting Rod
3054E and 3056E Industrial Engines Reference Material
3500 Industrial Engines Ammeter
3500 Generator Set Engines Pressure Switch
CPT372 Truck Mounted Pumper Starting the Engine
3054 and 3056 Industrial and Generator Set Engines Vibration Damper and Pulley
3500 Generator Set Engines Pressure Gauge
3500 Industrial Engines Differential Pressure Gauge
2002/03/11 Correction to Information Regarding the Need for Timing Calibration after Replacing the Engine ECM {1901, 1912, 1912}
3500 Generator Set Engines Pressure Gauge - Engine Oil
3618 Engine Oil Pressure Transducer - Test - Shutdown for Low Engine Oil pressure
3618 Engine Oil Mist Detector - Test
3618 Engine Particle Detector - Test
3500 Industrial Engines Vacuum Gauge
3618 Engine Thermocouple - Test - Main Bearings' Thermocouples
G3606 and G3608 Engines Fuel Control Valve - Remove and Install
3500 Generator Set Engines Pressure Gauge - Hydraulic Oil