Oil Leakage After Main Pump Shaft Seal Replacement {0663, 5070}
- Excavator
- 336D (S/N: PTB1-UP; SKE1-UP; J2F1-UP; PRF1-UP; MYG1-UP; W3K1-UP; WRK1-UP; MPL1-UP; ZML1-UP; PPN1-UP; JER1-UP; MDS1-UP; NLS1-UP; JBT1-UP; KKT1-UP; M4T1-UP; PGW1-UP)
- 336D2 (S/N: WDC1-UP; YCF1-UP; ZCT1-UP)
- 340D (S/N: JTN1-UP)
- 340D2 (S/N: HHK1-UP)
- 336D2 (S/N: WDC1-UP; YCF1-UP; ZCT1-UP)
- Mobile Hydraulic Power Unit
- 336D MHPU (S/N: J6D1-UP; M3M1-UP; M3N1-UP; L5X1-UP)
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
Some main hydraulic pumps have experienced oil leakage after servicing the main pump oil shaft seal due to missing plugs. If these plugs are not installed after seal replacement, dust and dirt accumulated at the shaft seal may cause repetitive failure.
Solution
Show/hide table
Illustration 1 | g06037822 |
Rubber Plug Installation (1) (2) |
It has been found that the rubber plugs at the front of the pump have been left off the pump after service was completed. The three plugs,
Caterpillar Information System:
340F Excavator Declaration of Conformity
325F Excavator Engine Supplement Soot Antenna - Remove and Install
325F Excavator Engine Supplement Electronic Control Module - Remove and Install
538 Forest Machine Machine Systems Specifications
303.5E2 CR Mini-HEX Machine ECM Electrical Power Supply - Test
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System CAN Data Link - Test
Wiper Arm May Interfere with Boom Tube Clamp on Certain Mini Hydraulic Excavators {5057} Wiper Arm May Interfere with Boom Tube Clamp on Certain Mini Hydraulic Excavators {5057}
303.5E2 CR Mini-HEX Machine ECM CAN Data Link - Test
XQP1100 Generator Set Engine Stopping
325F Excavator Engine Supplement Fan and Fan Drive - Remove and Install
An Improved Bucket Pin is Now Used on Certain 312D/D2 and 313D/D2 Excavators {6513} An Improved Bucket Pin is Now Used on Certain 312D/D2 and 313D/D2 Excavators {6513}
XQP150 Rental Generator Set Engine Starting
M314F, M316F, M318F, M320F and M322F Wheeled Excavator and Material Handler Machine Systems Piston Pump (Main Hydraulic) - Disassemble
Field Assembly Procedure for Dragline Buckets {6001, 7960} Field Assembly Procedure for Dragline Buckets {6001, 7960}
An Improved Assembly Procedure for Hammer Power Group Is Now Available for Certain H55E and H55ES Hydraulic Hammers {5077, 6333, 7555} An Improved Assembly Procedure for Hammer Power Group Is Now Available for Certain H55E and H55ES Hydraulic Hammers {5077, 6333, 7555}
New Pressure Sensor Gp Is Now Available for Certain Cat® Products {1000, 1408, 1439, 1718, 1906, 1924} New Pressure Sensor Gp Is Now Available for Certain Cat® Products {1000, 1408, 1439, 1718, 1906, 1924}
374F Excavator Restricted Visibility
814K Wheel Dozer Fuel System - Prime
815K Soil Compactor Bottom Guard Lowering
325F Excavator Engine Supplement Soot Sensor - Remove and Install
New Improved Oil Gauge Group Is Now Available On Certain Excavator Machine Engines {1326} New Improved Oil Gauge Group Is Now Available On Certain Excavator Machine Engines {1326}
303.5E2 CR Mini-HEX Machine ECM Sensor Signal (Analog, Passive) - Test
325F Excavator Engine Supplement Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
349F and 352F Excavators Restricted Visibility