Fuel Filter Base - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
B     | 9S-3263     | Thread Lock Compound     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply Tooling (B) to the threads of the mounting stud for the fuel filter. Apply the compound to the tapered end of the stud no more than 7.6 mm (0.30 inch) from the end.
- Install the stud and tighten to a torque of 70 ± 15 N·m (50 ± 11 lb ft).
- Inspect the condition of the O-ring seals. Replace the seals, if necessary.
- Install the O-ring seals on fuel filter base (5) .
Show/hide table
Illustration 1 | g01019035 |
Typical example |
- Install fuel filter base (5) on the fuel manifold with bolts (4) .
- Connect hose assembly (3) .
- Install fuel temperature sensor (2). Connect the sensor harness assembly to fuel temperature sensor (2) .
- Install new fuel filter (6). Follow the instructions on the fuel filter.
- Install pressure plug (1) .
Show/hide table
Illustration 2 | g01019031 |
Caterpillar Information System:
3500B Engines Auxiliary Water Pump - Assemble - Auxiliary Pump (Type 1)
2000/05/01 Corrections To Disassembly and Assembly Modules, G3600 Engines , "Pistons and Connecting Rods - Install" {1225}
3176C and 3196 Engines For Caterpillar Built Machines Fuel Filter Base - Remove
325, 325B and 325L Excavators Hydraulic System Pressure - Release
Alternator - Delco 21SI Alternator - Assemble
2000/05/01 Service Manual Module, RENR2484, "Electronic Modular Control Panel II+ (EMCP II+)" is Now Available {4490}
3126B Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
3176C and 3196 Engines for Caterpillar Built Machines Fuel Dilution of Engine Oil
EMCPII+ for Gas Engines GSC CID 0100 - FMI 03
3126B Engines for Caterpillar Built Machines Housing (Front) - Install
3126B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Flywheel - Remove and Install
325, 325B and 325L Excavators Track Carrier Roller - Remove
325, 325B and 325L Excavators Track Carrier Roller - Disassemble
325, 325B and 325L Excavators Track Carrier Roller - Assemble
325, 325B and 325L Excavators Track Carrier Roller - Install
325, 325B and 325L Excavators Track Roller - Remove
325, 325B and 325L Excavators Track Roller - Disassemble
325, 325B and 325L Excavators Track Roller - Assemble
325, 325B and 325L Excavators Track Roller - Install
G3406 Engine Overhaul (Major)
325, 325B and 325L Excavators Track - Separate
325, 325B and 325L Excavators Track - Connect
325, 325B and 325L Excavators Front Idler and Recoil Spring - Remove