Track Carrier Roller - Install
Installation Procedure For The Track Carrier Roller On CIPI Undercarriage Arrangements Which Are Based On 325, 325B, and 325C Track Type Excavators
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 8T-5255     | Hydraulic Jack     | 1     |
- Make sure that the shaft of the track carrier roller and the bore in the mounting bracket on the undercarriage are clean and free of dirt.
- Use two people to place the track carrier roller in position in the mounting bracket. The weight of the track carrier roller is approximately 27 kg (60 lb).
Show/hide table
Illustration 1 | g00652868 |
(x) Mounting bracket |
- Adjust the track carrier roller until distance (a), which is the distance between the outside face of the mounting bracket and the track carrier roller, is 7.0 ± 0.5 mm (0.28 ± 0.02 inch).
- After adjusting the position of carrier roller (3) in the mounting bracket, tighten bolt (2) .
Show/hide table
Illustration 2 | g00555721 |
- Make sure that carrier roller (3) rotates smoothly by manually turning the carrier roller. Slowly lower the track assembly onto the carrier roller with Tooling (A) .
Show/hide table
Illustration 3 | g00489356 |
- Tighten the tension of the track. Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for the correct procedure.
Caterpillar Information System:
325, 325B and 325L Excavators Track Carrier Roller - Assemble
325, 325B and 325L Excavators Track Carrier Roller - Disassemble
325, 325B and 325L Excavators Track Carrier Roller - Remove
3176C and 3196 Engines For Caterpillar Built Machines Fuel Filter Base - Install
3500B Engines Auxiliary Water Pump - Assemble - Auxiliary Pump (Type 1)
2000/05/01 Corrections To Disassembly and Assembly Modules, G3600 Engines , "Pistons and Connecting Rods - Install" {1225}
3176C and 3196 Engines For Caterpillar Built Machines Fuel Filter Base - Remove
325, 325B and 325L Excavators Hydraulic System Pressure - Release
Alternator - Delco 21SI Alternator - Assemble
2000/05/01 Service Manual Module, RENR2484, "Electronic Modular Control Panel II+ (EMCP II+)" is Now Available {4490}
3126B Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
3176C and 3196 Engines for Caterpillar Built Machines Fuel Dilution of Engine Oil
325, 325B and 325L Excavators Track Roller - Remove
325, 325B and 325L Excavators Track Roller - Disassemble
325, 325B and 325L Excavators Track Roller - Assemble
325, 325B and 325L Excavators Track Roller - Install
G3406 Engine Overhaul (Major)
325, 325B and 325L Excavators Track - Separate
325, 325B and 325L Excavators Track - Connect
325, 325B and 325L Excavators Front Idler and Recoil Spring - Remove
325, 325B and 325L Excavators Front Idler and Recoil Spring - Install
G3406 Engine Overhaul (Top End)
325, 325B and 325L Excavators Front Idler - Disassemble
325, 325B and 325L Excavators Front Idler - Assemble