Fuel Filter Base - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 185-3630     | Strap Wrench Assembly     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove pressure plug (1) and drain fuel into a suitable container for storage or disposal.
Show/hide table
Illustration 1 | g01019031 |
- Use Tooling (A) to remove fuel filter (6) .
Show/hide table
Illustration 2 | g01019035 |
Typical example |
- Disconnect the sensor harness assembly from fuel temperature sensor (2) .
- Remove fuel temperature sensor (2) .
- Disconnect hose assembly (3). Plug all openings immediately.
- Remove bolts (4) .
- Remove fuel filter base (5) and the O-ring seals.
- Remove the mounting stud for the fuel filter from the fuel filter base, if necessary.
Caterpillar Information System:
325, 325B and 325L Excavators Hydraulic System Pressure - Release
Alternator - Delco 21SI Alternator - Assemble
2000/05/01 Service Manual Module, RENR2484, "Electronic Modular Control Panel II+ (EMCP II+)" is Now Available {4490}
3126B Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
3176C and 3196 Engines for Caterpillar Built Machines Fuel Dilution of Engine Oil
EMCPII+ for Gas Engines GSC CID 0100 - FMI 03
3126B Engines for Caterpillar Built Machines Housing (Front) - Install
3126B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Flywheel - Remove and Install
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Disassemble
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Assemble
G3406 Engine Alarms and Shutoffs
2000/05/01 Corrections To Disassembly and Assembly Modules, G3600 Engines , "Pistons and Connecting Rods - Install" {1225}
3500B Engines Auxiliary Water Pump - Assemble - Auxiliary Pump (Type 1)
3176C and 3196 Engines For Caterpillar Built Machines Fuel Filter Base - Install
325, 325B and 325L Excavators Track Carrier Roller - Remove
325, 325B and 325L Excavators Track Carrier Roller - Disassemble
325, 325B and 325L Excavators Track Carrier Roller - Assemble
325, 325B and 325L Excavators Track Carrier Roller - Install
325, 325B and 325L Excavators Track Roller - Remove
325, 325B and 325L Excavators Track Roller - Disassemble
325, 325B and 325L Excavators Track Roller - Assemble
325, 325B and 325L Excavators Track Roller - Install
G3406 Engine Overhaul (Major)