3126B Engines for Caterpillar Built Machines Caterpillar


Housing (Front) - Install

Usage:

120H 124

安装步骤

表 1
所需工具    
工具     零件号     零件说明     数量    
A     8T-9011     合成洗涤剂     1    
B     4C-9500     快速硫化底漆     1    
C     1U-8846     密封垫密封胶     1    



    图 1g01028155

  1. 利用工具 (A) 清理前壳体 (3) 的接合面。

  1. 在接合面上涂抹工具 (B) 。 晾干底漆 3 到 5 分钟。

    注: 不要让工具 (C) 密封住前壳体 (3) 上的主机油道。

  1. 将工具 (C) 涂抹到接合面上。 均匀地铺开密封胶。 必须在涂抹密封胶后十分钟以内安装前壳体 (3) 。

  1. 将前壳体 (3) 安装到缸体上。

  1. 安装皮带张紧器 (2) 。



    图 2g01028154

  1. 安装前发动机支架 (1) 。

End By:

  1. 安装凸轮轴。 请参阅 拆解和组装, "凸轮轴 - 安装"。
  2. 安装曲轴前油封。 请参阅 拆解和组装, "曲轴前密封 - 安装"。

Caterpillar Information System:

3126B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Flywheel - Remove and Install
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Disassemble
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Assemble
G3406 Engine Alarms and Shutoffs
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Remove
3176C and 3196 Engines for Caterpillar Built Machines Throttle Position Sensor
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0100 - FMI 02 (for MUI and PEEC Engines)
2000/05/08 Improved Caterpillar O-ring Face Seals are Now Available {7555}
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 11 Secondary Engine Speed Sensor mechanical failure
EMCPII+ for Gas Engines GSC CID 0100 - FMI 03
3176C and 3196 Engines for Caterpillar Built Machines Fuel Dilution of Engine Oil
3126B Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
2000/05/01 Service Manual Module, RENR2484, "Electronic Modular Control Panel II+ (EMCP II+)" is Now Available {4490}
Alternator - Delco 21SI Alternator - Assemble
325, 325B and 325L Excavators Hydraulic System Pressure - Release
3176C and 3196 Engines For Caterpillar Built Machines Fuel Filter Base - Remove
2000/05/01 Corrections To Disassembly and Assembly Modules, G3600 Engines , "Pistons and Connecting Rods - Install" {1225}
3500B Engines Auxiliary Water Pump - Assemble - Auxiliary Pump (Type 1)
3176C and 3196 Engines For Caterpillar Built Machines Fuel Filter Base - Install
325, 325B and 325L Excavators Track Carrier Roller - Remove
325, 325B and 325L Excavators Track Carrier Roller - Disassemble
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.