CID 0342 FMI 11 Secondary Engine Speed Sensor mechanical failure
Conditions Which Generate This Code:
The signal for the secondary engine speed/timing sensor is lost for more than one second.
System Response:
The Electronic Control Module (ECM) will log the diagnostic code.
- Engine misfires during starting
- Engine shutdown
Note: The engine will shut down only if the primary engine speed/timing sensor and the secondary engine speed/timing sensor fail.
Test Step 1. Perform the following diagnostic procedure: Engine Speed/Timing Sensor Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
C-10, C-12, C-15 and C-16 Industrial Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
Alternator - Delco 21SI Alternator - Disassemble
G3516B Engines MID 036 - CID 0443 - FMI 03 Crank Terminate Relay short to +batt
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Engine Speed/Timing Sensor - Calibrate
3412 Generator Set Engines Speed/Timing Sensor
3034 Engine for Caterpillar Built Machines Basic Engine
G3516B Engines MID 036 - CID 0336 - FMI 02 Incorrect ECS Switch inputs
325, 325B and 325L Excavators Final Drive
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 02 Loss of Secondary Engine Speed signal
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Starting Motor System
G3516B Engines MID 036 - CID 0324 - FMI 03 Warning Lamp short to +batt
G3516B Engines MID 036 - CID 0323 - FMI 03 Shutdown Lamp short to +batt
2000/05/08 Improved Caterpillar O-ring Face Seals are Now Available {7555}
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0100 - FMI 02 (for MUI and PEEC Engines)
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Diagnostic Codes
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor
3176C and 3196 Engines for Caterpillar Built Machines Throttle Position Sensor
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Remove
G3406 Engine Alarms and Shutoffs
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Assemble
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Disassemble
3126B Engines for Caterpillar Built Machines Flywheel - Remove and Install
3126B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3126B Engines for Caterpillar Built Machines Housing (Front) - Install